Electronics Forum | Wed Jul 15 01:28:44 EDT 2009 | asozio
Just curious if anyone here has experience with a Panasert RH6 Radial Insertion machine. Ours is having some problems detecting insertion, appears to be failing to sense when the legs are cut and is triggering the error.
Electronics Forum | Wed Mar 24 07:10:32 EDT 2010 | aj
Hi all, I would like some recommendations on what machines are best suited to Automated Insertion of plated through hole LEDs. I am sure there are plenty of pitfalls associated with this type of process aswell, so if you could share these aswell.
Electronics Forum | Thu Sep 12 11:27:21 EDT 2013 | rway
Yes. Typically terminals, large relays, displays, parts with mounted heatsinks. This is typically what you see on hand-insertion lines. Other parts with specialized packaging may not be able to be auto-inserted either. Most axial and radial leade
Electronics Forum | Fri Jul 24 16:37:47 EDT 2015 | cnotebaert
to my knowledge it will always be manual insertion,, if you mean reflow, not insertion, I always apply solder to one side, reflow, then apply tacky flux pre print to the already soldered pins, print op side, assemble part then send through placement
Electronics Forum | Mon Jul 13 15:31:20 EDT 2015 | antoine_fradette
i am looking to buy a Press-fit machine and was wondering if the foolowing tools work with the Tyco MEP-6T press is a good choice? molex: insertion:62202-9940 extraction:62203-0150 molex: insertion:62202-9780 extraction: 62202-9790 Thanks
Electronics Forum | Mon May 13 06:15:12 EDT 2019 | dhanish
how to control warpage on panelized pcb during reflow process.we are already running with pallet.Encountering problem to insert the pcb into pallet after first reflow cycle.The insertion is being done by robotic arm. Any recommendation on the profile
Electronics Forum | Thu Jul 23 19:04:24 EDT 2020 | robl
The modular inserters usually have them built into the feeders, which is part of why each feeder is so expensive. I'm sure I saw one system with a separate clinch unit but they are all dog slow compared to a rad 5 or 8 or 6241D+.
Electronics Forum | Fri Apr 30 07:29:02 EDT 2021 | dilogic
Status output is pin 2. On pneumatic feeders it only shows if the feeder is inserted, on electric feeders it doubles as feeder insertion and goes off if the tape is exhausted or feeder is jammed
Electronics Forum | Tue May 29 16:02:36 EDT 2001 | genny
500 insertions � 50 m gold => 300 insertions � 30 m gold => 50 to 75 insertions � 20 m gold => 10 insertions. " Dave stated that the 'm' referred to micro-inches. I could probably insert this board 1000's of times without a problem. Am I missing so
Electronics Forum | Fri Feb 11 08:44:26 EST 2005 | pemnut
We use these machines to insert swedge pins. When I first started here, there were certian programs that we ran that required us to put in a machine offset of +.120 in the X which is a lot. after learning the machines better, I realized that whoever