Electronics Forum | Mon May 13 06:15:12 EDT 2019 | dhanish
how to control warpage on panelized pcb during reflow process.we are already running with pallet.Encountering problem to insert the pcb into pallet after first reflow cycle.The insertion is being done by robotic arm. Any recommendation on the profile
Electronics Forum | Fri Apr 30 07:29:02 EDT 2021 | dilogic
Status output is pin 2. On pneumatic feeders it only shows if the feeder is inserted, on electric feeders it doubles as feeder insertion and goes off if the tape is exhausted or feeder is jammed
Electronics Forum | Tue May 29 16:02:36 EDT 2001 | genny
500 insertions � 50 m gold => 300 insertions � 30 m gold => 50 to 75 insertions � 20 m gold => 10 insertions. " Dave stated that the 'm' referred to micro-inches. I could probably insert this board 1000's of times without a problem. Am I missing so
Electronics Forum | Fri Feb 11 08:44:26 EST 2005 | pemnut
We use these machines to insert swedge pins. When I first started here, there were certian programs that we ran that required us to put in a machine offset of +.120 in the X which is a lot. after learning the machines better, I realized that whoever
Electronics Forum | Wed Feb 01 10:53:56 EST 2006 | edruppert
AMS, Are you aware that you will have to purchase several types of insertion equipment for different part types? You will need an axial inserter, radaial and DIP inserter to cover the gamut of thru-hole insertion. Even then you may not cover oddba
Electronics Forum | Tue Jun 27 10:51:42 EDT 2000 | Ioan
Hi Bill, there are a couple of things you should check. Most likely you have too much paste which is squashed at the insertion of the cap. - the paste height, around 7 mils should do. Too much paste will cause shorts under the cap at insertion which
Electronics Forum | Thu Apr 05 12:45:45 EDT 2001 | Claude_Couture
On mixed technology PCBs, we find numerous blow holes on the solder joints of radial parts (electrolytics, LEDs, etc). The solution that works so far is to cut the leads very long in the radial inserter so that the part is kinda loose and the air in
Electronics Forum | Fri Apr 05 08:35:30 EST 2002 | jax
When the remedy is as easy as not inserting the part until after wave........, maybe say at test, you shouldn't need more than one problem. If you think there is a problem, change it. Since we won't know as much about your process as you,( paste/flux
Electronics Forum | Sat Feb 12 09:24:29 EST 2005 | primus
We don't have any automated machines (UIC) that insert anything into holes larger than our terminals, so about 0.050" is as big a hole we ever have to use before we've plugged them with something. Since we also do a fair amount of Man-U-Sert (yes, yo
Electronics Forum | Thu Aug 30 11:02:51 EDT 2007 | gmoritz
... talking two-lead LEDS with 2.5mm pitch ... Yes. That's what we are working with. > are the LED terminals shape were Square or > the naturally rounded? Some are round. Some are square. One is U-shaped. > Due to different insert rotations,