Electronics Forum | Wed Mar 27 17:14:10 EST 2002 | davef
It is certainly a process indicator. What is causing this condition? Is it a chip that has its toes over the edge, edging towards tombstoning? Contact: * Jack Crawford [ JackCrawford@IPC.ORG ] * Mel Parrish [ mparrish@SOLDERINGTECH.COM ]
Electronics Forum | Mon Nov 11 18:12:33 EST 2002 | SkateMonkey
I have heard of "Cat5 duplex surface mounts". Do these exist? And if they do, do they have built in Cat5 jacks, or do you have to manually put snap-in jacks into them?
Electronics Forum | Thu May 18 03:15:32 EDT 2017 | wama
We are soldering wire 26AWG to jack socket. However after went through washing, baking, coating, curing processes the wire breaks (at joining point with jack socket) during wire dressing. We have tried to increase and decrease the solder amount but r
Electronics Forum | Wed Mar 08 21:11:41 EST 2000 | Dave F
Jack: I'll think about the latter point over my next McEwan's. Dave F
Electronics Forum | Wed Mar 08 21:11:41 EST 2000 | Dave F
Jack: I'll think about the latter point over my next McEwan's. Dave F
Electronics Forum | Tue Mar 27 12:44:36 EST 2001 | Mike Lynn
Try Veeco Electrofab (714)525-6257 (Anaheim, CA) - ask for Jack Singh.
Electronics Forum | Thu Jun 01 23:32:26 EDT 2006 | ec
Hi Jack, Already send to you.
Electronics Forum | Wed Dec 20 23:45:51 EST 2006 | Jack
Hi all, Any comment after read this article? Best wishes, Jack
Electronics Forum | Sat Dec 23 03:46:13 EST 2006 | Jack
Hi Davef, I think you are right..Rgds, Jack..
Electronics Forum | Fri Jan 04 15:11:40 EST 2008 | bigdaddysoy9
Try reloading the software ya jack leg.
