Electronics Forum: job (Page 96 of 224)

Circuit cam related software

Electronics Forum | Wed May 25 23:08:29 EDT 2005 | eb

Hello, I'm considering purchasing circuit cam at the facility I work at. I'm pretty familiar with circuit cam from a previous job and was wondering if anybody knows of any other similar types of software that can perform the same types of operations

New SMT line - Need equipment selection help

Electronics Forum | Wed Jun 28 14:18:53 EDT 2006 | doug

Yes, you are right, but I am still here! I went with Mydata - at least for now - rock steady, easy to use, etc. We were up and running in 2 days. Ok, so you watch it place and think perhaps you can personally go just as fast, but it does a fine job.

HOW TO REDUCE MACHINE SET-UP TIME???

Electronics Forum | Thu Jun 09 15:56:19 EDT 2005 | james

I would love to buy enough feeders, just for the common parts but unless I find somewhere cheap to buy them it can very expensive. We use our own internal part numbers with using smart feeding stations. Also we are going to try to leave all the comm

HOW TO REDUCE MACHINE SET-UP TIME???

Electronics Forum | Fri Jun 10 06:52:54 EDT 2005 | mmjm_1099

This sounds like exactly what I am going through here. If you come up with a nice solution please post it. One of the things I have done is make top and bottom programs similar as possible. No I didn't say all programs the same overall just each job

WIP tracking

Electronics Forum | Tue Jun 14 18:33:48 EDT 2005 | slthomas

Any tried and true methods for tracking WIP with a paper system? A good white paper on the subject or even a decent book reference that covers the topic would be great. It's really never been done here before and beyond establishing time standards a

Stencil fiducials

Electronics Forum | Wed Jun 22 11:11:09 EDT 2005 | geb

Thanks for your help. I have resorted to using pads as the PCB doesn't have fids particularly close to the stencils fids. All previous jobs have had fids in the same place on the stencil as the PCB. The printer has a wiper paper which I have set to e

System is too slow, Will memory/speed increase do job?

Electronics Forum | Sat Jul 02 19:25:37 EDT 2005 | Thaqalain Mahdi

Tom Thanks for reply,u right I am dedicating more than enough time for upgrading and troubleshooting! How can I set back the speed to the lower ram, (100MHz)? Get a bigger and Faster hardrive, 7200 and 10,000 RPM will zip you along! (What these f

Poor reflow over gold plating

Electronics Forum | Tue Jun 28 10:51:32 EDT 2005 | mattkehoe

Thanks for the replies, - solder paste used ? NC ? other ? Water soluble 63/37 paste - reflow in Air or N2 ? Infrared - temp ramp up before soack (�C/second) ? Will have to check. This profile has been used on numerous gold plated boards in our

BGA Rework Equipment

Electronics Forum | Wed Mar 08 15:37:28 EST 2006 | Mike H

I think Peter gave up since I have not seen anything from him since original question on comparing Metcal to Airvac. I personally prefer SRT to either of these two. SRT proven that the software and its' semi or full auto operation is superior to any

BGA Rework Equipment

Electronics Forum | Tue Aug 15 00:46:21 EDT 2006 | ahmad

Guys I do not know what you guys are trying to prove. If you have a BGA job to be done JUST forget about using any equipment that is using hot air since you will get into a lot of trouble. It will bend the PCB and need nozzole for each IC find an ER


job searches for Companies, Equipment, Machines, Suppliers & Information