Electronics Forum | Fri Apr 29 06:13:26 EDT 2022 | 1_manuel
Hi there, I'm pretty new to the SMT manufacturing stuff, please be kind. I have to mask up some parts of a stencil. Is there a recommendation for some masking tape I could use? It should be sticky enough for temporary use but not that sticky that i
Electronics Forum | Thu Jul 14 03:16:18 EDT 2022 | acouto
Thanks for the feedback, I've been having some problems with the motor overload in the conveyor and central reel whenever there is cleaning by the external company. After analyzing I always find talcum powder and lubricant (it looks like cement) on t
Electronics Forum | Wed Oct 19 14:03:47 EDT 2022 | proceng1
Low Temp solder and a cooler profile should certainly help. I do believe that the unbalanced copper is the culprit, but you could try to prebake some boards. To eliminate some kind of manufacturing defect from the equation. Though I'm pretty sure i
Electronics Forum | Tue Dec 13 19:33:06 EST 2022 | proceng1
Does yours have the removeable hard drive that unlocks with a key and the whole thing comes out? Try plugging the HDD directly in, and don't use the adapter part. It's kind of tricky, but I was told by the service techs that a bunch of those adapt
Electronics Forum | Tue Feb 07 12:26:07 EST 2023 | nitroone
Hi Tom, thank you so much for your feedback! I have been looking into getting better extractors for the work areas, However we don't have any for PCB washer so that might be one of the issues too. What kind do you use for the PCB washer? I'm very new
Electronics Forum | Sat Mar 11 07:33:52 EST 2023 | klauss
There's two kind of nozzles with different dimensions we use. One of them works good but the another one gives a head problem sometimes. The head picks the nozzle and gives the vacuum error despite the camera recognize it. So i make another head pi
Electronics Forum | Tue Nov 07 06:36:39 EST 2023 | ravikumargv
Dear All. Good day.. We have one Omniexcel dual conveyor reflow and recently we had PC got gone bad and now we replaced new mother board and hard disk, but we don't have the previous PC backup, now we need the software. kindly help us to share the
Electronics Forum | Sun Dec 31 17:16:37 EST 2023 | ravikumargv
Dear all, We are facing Siemens F5HM machine zero point calibration issue, due to fiducial issue and we need to teach the fiducial position and it's not possible, kindly help us how to teach the zero point fiducial for calibration
Electronics Forum | Wed Apr 03 22:07:13 EDT 2024 | compit
Not every program can clone a CF card. I did it but I need to check with what kind. You can also simply insert a new CF card into the machine, INSTALL DOS from floppy disks (same version) and then COPY the entire disk EXCEPT the system files (msdos.s
Electronics Forum | Wed Nov 10 15:08:18 EST 1999 | John Thorup
I would be afraid to have this kind of basket holding my boards. Yes, in most cases, you would not get damage if the boards were closed inside of a good, metalized (silver colored) ESD protective bag. The problem is that the boards usually have to c
