Electronics Forum | Mon Dec 09 21:00:39 EST 2019 | sssamw
Did you solve this issue? It doesn't much look like the flux dried out, ti should be across whole board and has much more same defect if flux dried out. Did you have failure ratio data to show the defect location, for example 10% at location A on bo
Electronics Forum | Tue Feb 04 14:03:13 EST 2020 | dekhead
As long as pressure is set properly (may require re-adjustment when adding / removing modules) then have not seen / heard of issues with damage to bottom side components. This assuming that rubber tips are in place and in good shape. I have a custome
Electronics Forum | Tue Sep 15 14:42:20 EDT 2020 | kumarb
Some threads that may help: https://electronics.stackexchange.com/questions/398199/filter-harmonics-in-ac-power-line still recommend that you contact Heller for advice. Consider to insert a UPS system between your hydro and one of the LED light fi
Electronics Forum | Wed Apr 28 17:45:41 EDT 2021 | mishafockin
Flexibility (if what I am thinking about flexibility is correct) is more important than speed. Most of the time spent on reloads, not the runs. We have high mix and fairly low volume (100-1000) Medium complexity QFPs, 0402, LEDs 100-2000 components p
Electronics Forum | Thu Aug 05 14:55:32 EDT 2021 | tomdegas
Tom I did as you instructed but same results so I actually changed the harness that has the two sensors (LED and RECEIVER) on the Z motor with a new spare I had hoping that was the problem. Alas that didn't solve it either. Any other suggestions?
Electronics Forum | Mon Apr 18 11:45:04 EDT 2022 | dontfeedphils
If you're 100% certain you have the correct nozzle for this package you could check to see if your PnP machine has an option for "Auto Adjust Pickup Position" or something along those lines and try changing it (if it's currently on, try turning it of
Electronics Forum | Mon May 09 19:27:19 EDT 2022 | mikevb
Thanks for the response. Yes, the z motor initializes in the service program just fine. It moves and reads a position. Also in the service program, I try to test the z force sensor and it gives me the same error - no z indicator at all. All cables ar
Electronics Forum | Fri May 13 22:24:47 EDT 2022 | glasscake
Try adding blow after mount before head up if your machine lets you. Make sure your placing the part into the solder paste as that will add some holding force as well. If your tips are spring loaded you can do some 0.5mm additional mounting height.
Electronics Forum | Thu Jun 16 03:35:46 EDT 2022 | leaderway0
AI/SMT spare parts and SMT equipment vendors from China-Leaderway Industrial Co., Ltd. The main distribution brands are Fuji, Samsung, Juki, Yamaha, Universal, Panasonic, Siemens, and Sony. Our websites: http://www.leadersmt.com Contact us !!! Email
Electronics Forum | Fri Feb 09 01:46:55 EST 2024 | erikfriesen
I have a 2005 DEK Horizon 02i, the cmos batt was dead, so I replaced, and reset the bios. The device hangs in initialization, eventually erroring out. The vision led's blink rapidly during this period. Also, the card shows an error in device manag