Electronics Forum | Thu Nov 18 11:47:17 EST 2004 | Nate
We currently redoing our floor layout and need to squash our SMT line into a smaller, rectangular cell. We currently use a manual printer/stenciler, pick and place, reflow oven, and aoi inspection machine. Can anyone give me any links to any differ
Electronics Forum | Thu Jun 23 15:31:46 EDT 2005 | james
The ideas so far are good, but yet remember, we are running 4 different lines with "1" set of parts that are never removed from the feeders. We can not get purchasing to buy extra reels of the of the most used parts, and these parts travel from line
Electronics Forum | Mon Jun 13 09:17:05 EDT 2005 | russ
Some machines may require that the two locals be used to calculate a center point where some (probably most) just use them as a second positional identifier. The fiducials are programmed as just XY and just prior to placement the machine will read th
Electronics Forum | Fri Aug 12 21:25:18 EDT 2005 | fctassembly
Hello Pete, Do you know how long Electrovert warranties their coated pots/pump equipment in use with SAC alloys? Also, does the warranty cover an operator scratching the surface while cleaning the pot in normal maintenance procedures? The good news
Electronics Forum | Fri Sep 23 23:21:53 EDT 2005 | Mats
Please explain Your line configuration needs or the volume by: components/panel/day/operators(people)/investments/yield/customer requirements/Your own req./etc. that You need. In Your initial thread You said that You had a low volyme production and
Electronics Forum | Wed Nov 16 18:25:11 EST 2005 | Mike F
Check out the Unit Design web site and look at their drag soldering machines. You do not want to try to do any of this manually. How consistent are your operators when working above a 500 F solder pot? I strongly recommend you buy one of the books
Electronics Forum | Tue Jan 17 17:28:47 EST 2006 | mrduckmann2000
Adlsmt, We had an issue where an Engineer setuo his own passwords on our machine, he was then laided off and nobody knew the passwords. Electrovert gave us the following passwords to try: Electrovert Wave Solder Logon Id Supervisor Password Pass
Electronics Forum | Thu Jan 18 12:37:21 EST 2007 | slthomas
At this point I'm comfortable with my suppliers, although we will definitely look at the machines running and verify they'll build our products to our satisfaction. All three machines meet or exceed our requirements for component range, speed, accu
Electronics Forum | Fri Mar 02 11:26:17 EST 2007 | ausajid
hi thank you very much for your advice. there was only one option i beleive that should work, i have tried that option today, but still the machine goes to the alternate carrige instead of alternate feeder. the option was in operation mode, alternat
Electronics Forum | Wed Mar 28 01:02:27 EDT 2007 | John B.
Looking at the Emerald machines, they do seem like they'd fit the bill quite nicely. Other than the operating system, is one generation markedly better than the others? I have all the data on the X2 from the manufacturer's site, but what changed from
