Electronics Forum | Mon Jun 05 18:50:10 EDT 2017 | caurbach
Hi Zac, My 2 cents: We had similar problems on a board in the same situation (tin-lead HASL, very long leads, low pot height, high pump RPM). Trimming the leads shorter, moving the pot closer to the board, and dropping the pump speed down to sane
Electronics Forum | Sat Jul 13 11:14:55 EDT 2019 | SMTA-Richard
Yes, it is time and temperature, but it is also speed and distance. Even though you can run a longer machine faster, the boards have a longer distance to travel and you do too, so the cycle time per board may not improve be reduced as much as you th
Electronics Forum | Fri Mar 06 08:32:20 EST 2020 | SMTA-Ken
Volume dictates throughput required. High-Volume = Requires redundant processes, Two Lines. Mid-Volume = Dual Lane or Two Lines. Low-Volume = Single Line. So Mid-Volume is the only volume scenario that a case for dual lane could be made. Dual Lane :
Electronics Forum | Fri Apr 09 15:52:57 EDT 2021 | daniellongo
The MPM Accuflex will unload the PCB to the conveyor when an explicit button command is given in Configure/Product transfer/FMI/Advanced/"Unload" or if there is a stretch error and the operator is given the choice to "Unload PCB",
Electronics Forum | Wed Feb 23 13:22:31 EST 2022 | micropak
Congratulations on being operational again... Few years ago, I acquired a Siplace line (S20 + F3 + S15 + G2) and I rebuild it completely because the line was lying idle for more than 10 years. All belts, pneumatic cylinders, pneumatic pipes were cha
Electronics Forum | Fri Mar 11 10:33:52 EST 2022 | gibs
Hi Ricardo, If you want, I can scan for you the CP20CV manual.... I can send you via we-transfer I have : - Operations manual (337 pages) - Reference manual (141 pages) - Tape feeder manual (127 pages) - Technical drawing/Electric Schematic (154
Electronics Forum | Tue May 09 14:30:47 EDT 2023 | gwideman
I realize this request is an incredible longshot, but... Anybody happen to know the initial default username and password for ERSAsoft 2.1? We have a hard-working antique Hotflow 3, and decided to try setting up ERSAsoft for it. Comes on two floppi
Electronics Forum | Thu Apr 11 16:23:20 EDT 2024 | cyber_wolf
I have been in the arena with both new and used. The 10 plus year old Juki's are solid machines unless someone neglected PM's. However...if something breaks and you can't repair yourself or source to third party, Juki will stick it to you. They ma
Electronics Forum | Fri May 10 01:30:15 EDT 2024 | nicholascarson
Access the Calibration Screen: Navigate to the system settings menu on the HMI and find the calibration option. This may require entering a password or accessing a service mode, depending on the machine's security settings. Begin Calibration: Once
Electronics Forum | Thu Aug 08 11:39:53 EDT 2024 | stephendo
I used an early Mirtec about 20 years ago. I think none of us had previous experience with AOI at the time. We of course had a learning curve abut Mirtec was great with support. But we had trouble with false fails and part of the problem was bad imag
