Electronics Forum | Thu Nov 14 15:46:28 EST 2019 | assuredtech
> I think it has something to do with the > communication between the 2 computers. Plug a > monitor into the back computer rack and see if > there is an error showing when its trying to boot > up. Its been a long time....so dont qu
Electronics Forum | Thu Jan 03 15:53:28 EST 2019 | cbeneat
We did figure out the issue. The plastic cover inside the LED lighting unit had a slight film covering it, which made the picture slightly hazy. We had to disassemble the LED module to get at it, cleaned it and it was fine. I didn't think this would
Electronics Forum | Mon Nov 19 10:53:29 EST 2018 | spoiltforchoice
Well the website says "Mounting capability (under optimum conditions as defined by Yamaha Motor)" which normally means if they cheat like mad and extrapolate to that number using the absolute fastest path from pick to place. How close you can get to
Electronics Forum | Tue Nov 20 12:06:21 EST 2018 | reckless
Great explanation! In my operation I have all tiny chips, 1 SOT223 being largest part but I do have 1 3mm tall inductor which won't work with this machine. Other than 1 part I could run my entire production on it. Also looks perfect for LED produc
Electronics Forum | Sat Dec 08 22:44:59 EST 2018 | youngbuck
Hi, Was wondering if anybody has any experience with F5 with the conveyors will work sporadically. If I put a board on the input sensor in which it sees it will work, the next 5 minutes it won't work. Could this relate to the K2 relay, if so does any
Electronics Forum | Wed Jan 02 10:20:10 EST 2019 | jdengler
Sorry, I looked at an IP-3 not 2. It looks like for the IP2 they bundle the MTU and machine proper together so it should be sending the data when you transmit the one file. Do the axis travel in the correct direction? If yes the only thing I can
Electronics Forum | Sat Jan 26 15:47:10 EST 2019 | dfl
I'm with an annoying problem with an IV-c. Almost all the time the Y-axis "stuck" when the machine is homing. The motor tries to move the axis but only make a sound. If I move the axis by hand it can complete the homing and then goes to the IDLE. So
Electronics Forum | Wed Jan 30 15:08:10 EST 2019 | dfl
MM, exchange the cards doesn't make any difference. The problem happens when the machine is moving from left to right. Right to left works all the time. bobpan, thanks, I completely missed this one. The default was 0 and now is set to 1. The build c
Electronics Forum | Wed Jan 30 08:27:37 EST 2019 | mst3000
Hi there. We are facing an issue with the placing head of our SMT machine SIEMENS SIPLACE CF 2004 model where the vacuum reading is low (820 instead of 900). This is resulting in that the components are either falling off when the head moves onto the
Electronics Forum | Tue Feb 12 11:26:31 EST 2019 | aldrich17
Does anyone have any info. on an "E869" error code on a Phillips Topaz X SMT machine. Error screen shows "Nozzle down limit sensor is off in A-table YV100X:N2323 YV100XT:n2223 Please check sensor and remove to the cause of this sensor being off.
.jpg)
Buyer, Seller, Broker of Electronic Assembly Equipment
Equipment Dealer / Broker / Auctions
309 West Pickle Alley
Rushford, MN USA
Phone: 507-864-7477
