Electronics Forum | Mon Feb 01 18:19:01 EST 2010 | wmeliane
Hi, We are looking to purchase a Juki CX-1 machine. Does anyone have any experience with the machine? Any feedback would be greatly appreciated. Thanks.
Electronics Forum | Tue Feb 02 08:41:29 EST 2010 | alexino76
It is a really precision machine and very easy to use. If you need high precision and perfect reiability on your mount process could be one of the best machine.
Electronics Forum | Thu Feb 11 16:33:08 EST 2010 | dougt
Contact Systems cs400e It's a semiautomatic thru hole machine that incorporates hand placement with a machine cut and clinch, was (probably still is) the benchmark in the industry.
Electronics Forum | Sat Mar 13 10:42:45 EST 2010 | davef
Manuel: What is the objective of OEE? It seems to say it's OK to give-up 4% of your quality, if you can increase your machine speed by 5%. Does it work on machines that are not capacity constrained?
Electronics Forum | Mon Mar 01 16:11:03 EST 2010 | kjs123p
I have Siemens F4 and S20 machines. Does anyone know of a spare parts supplier for these machines besides Siemens? Thanks in advance for the replies.
Electronics Forum | Thu Mar 18 07:58:43 EDT 2010 | mun4o
It is a pressurized system, and , Yes , there are a message "No flow nozzle 1".Our machine have not 'ShoRate' gauge at the back of the machine.There are only 3 gauge for flow on the front side , like watch ???
Electronics Forum | Wed Apr 07 03:44:40 EDT 2010 | jackevest
The missing rate spec. of normal machine is under 0.3%, for our experience 0.1% is normal for average, if you can maintain the machine well, like the nozzle cleaning, feeder maitain...you can keep the 0.05%.
Electronics Forum | Tue Mar 30 06:27:22 EDT 2010 | ristikas
It happens on the middle of the stecil cleaning. The camera and the cleaner will stay under stencil in half way back. Then machine asking the initate the motors. If to press initate then the pcb stopper will hit the rails. Usually we move camera and
Electronics Forum | Tue Apr 13 14:56:22 EDT 2010 | charlesyeh_wellex
Hi: Did any one know about how to connect boardFLO to Fuji CP machine? I did not have communication cable between both two machine. Thank you
Electronics Forum | Thu May 20 10:01:23 EDT 2010 | jmw
Just a slight correction....the quad align card is located at the back rear right of the machine (in a cage). If it is a cyber-optics 4c machine....the laser align card is in the front card rack to the far left.
Buyer, Seller, Broker of Electronic Assembly Equipment
Equipment Dealer / Broker / Auctions
309 West Pickle Alley
Rushford, MN USA
Phone: 507-864-7477