Electronics Forum | Fri Jul 21 14:47:53 EDT 2017 | sumote
I commend you for doing your diligence. It sounds like you have a solid plan, and a few decisions to make. I have used Assembleon machines before, a Topaz X and a Emerald X. They seem to be a good compromise between speed and cost. If you are close
Electronics Forum | Thu Jun 08 16:40:08 EDT 2017 | sumote
I have used one (actually 2) of these machines. The upside is you can point to the print-out and tell your customers that you do test for cleanliness, and you pass. The reality of this test is that it tests for exactly 1 type of contamination. The
Electronics Forum | Sat Jul 08 12:33:07 EDT 2017 | dleeper
As others have mentioned, using your P&P machine is as accurate as any other solution and has the advantage of using equipment you already have. Most, if not all, P&P machines should have some sort of teach mode where you center the camera over the f
Electronics Forum | Thu Jul 20 03:46:07 EDT 2017 | danallens
We recently bought a Scanspection machine second hand but there seems to be a problem with the PC side of things. AOI Systems have not been helpful at all and won't support the machine. Does someone have any experience with this machine or can give
Electronics Forum | Mon Oct 09 06:04:47 EDT 2017 | bobpan
Hello Joyce, Usually I use Very Large cable ties and secure the heads in the opposite corners. I also tie up the z rods or put some plastic tube under the top portion to keep them up. Remove the monitor and bracket off the side of the machine...and i
Electronics Forum | Thu Dec 14 01:28:23 EST 2017 | tsvetan
"I would expect that any intelligent feeder enabled machine would pull the correct part no matter where it is placed on the machine (not forced by the program)" this is true, but you have to tradeoff the setup time vs production time per board. You
Electronics Forum | Tue Dec 19 16:30:23 EST 2017 | charliedci
We have several selective soldering machines, that because of several minutes of process time per PCB, one operator can keep 2 or sometimes 3 machines loaded and running. Other days only 1 machine is running but operator does not have enough time to
Electronics Forum | Wed Dec 20 10:44:31 EST 2017 | bobpan
The z-rod bellows on head 2 and head 3 are slightly bent. The machine will show you this error if the runout is over 6.5 mils. This is usually caused by too much z when picking parts out of a vib or tray feeder. The machine will probably run. I ha
Electronics Forum | Mon Jan 15 04:17:34 EST 2018 | smtspareparts
Hi You cannot find any offline programing software on your local market? Here in China,the yamaha yv machine is equivelent to topaz machine,and there are many offline software like YGOS,P-TOOL,COORD10,YVOS2,just for the machines,and they can
Electronics Forum | Wed Jan 17 07:58:31 EST 2018 | lokiz
Greetings, I have been told that auto rail width with the Samsung SM320 is a purchased option opposed to a standard feature. What I would like to know is what all comes in the auto rail width kit. It looks to me like the wire harness where the rai
Buyer, Seller, Broker of Electronic Assembly Equipment
Equipment Dealer / Broker / Auctions
309 West Pickle Alley
Rushford, MN USA
Phone: 507-864-7477