Electronics Forum | Mon Jul 03 22:48:42 EDT 2006 | eyryren
Dear ve7khz We are the manufacturer of SMT accessorial material.stencil clean roll and splice tape.We are can manufacture many style stencil clean roll for kinds of screen printer machine and splice tape special for kinds of placement machine. If yo
Electronics Forum | Thu Sep 28 17:40:41 EDT 2006 | fujismt@btconnect.com
Fuji AIM users. If you wish to splice 8mm component tape reels using this machine, visit http://www.fujismt.com and look at Fuji Chemical FC8A Joint Tapes. Ideally suited and in use on the Fuji AIM machine, FC8A is easy to use and available for next
Electronics Forum | Tue May 31 12:04:04 EDT 2005 | chunks
They both have good and bad points, depending on part size and such. The speed of the turret is great but the large part size capability and co-planarity check some of the X-Y machines is a life saver. I'm surprised no one has come up with a combon
Electronics Forum | Tue May 31 22:16:24 EDT 2005 | hottipmfg
Hi, I'm new to this field. I'm looking for a third party software that can program the Zevatech FM720 Pick&Place machine. I know ScanCad provides service for this machine. Any knowledge to a reasonable cost software is appreciate very much. //Andrew
Electronics Forum | Wed Jun 08 13:06:36 EDT 2005 | jimby
You will have to machine the part off down to the top of the balls. Wick solder off from individual sites one at a time. All that will be left is Parylene shell where balls once were. Take an orangestick and alcohol to break up and remove. Tricky par
Electronics Forum | Thu Jun 09 12:21:07 EDT 2005 | ratsalad
James, I have worked at a couple of different companies and both have reduced their changeover times significantly. What type of placement machines do you have? Do you use customer part numbers or do you have your own internal part number for co
Electronics Forum | Mon Jun 13 16:15:04 EDT 2005 | peter ng
Dear all, We faced some major issue in setting our company target to 500 points per million at machine throw rate.It might be caused by human error,machine,feeder,environment or other factor.We need some opition and advise on how to achieve this targ
Electronics Forum | Mon Jun 13 16:17:30 EDT 2005 | peter ng
Dear all, We faced some major issue in setting our company target to 500 points per million at machine throw rate.It might be caused by human error,machine,feeder,environment or other factor.We need some opition and advise on how to achieve this targ
Electronics Forum | Mon Mar 05 03:57:39 EST 2007 | reza karbaschi
This is a technical forum for the SMT assembly > process. Try posting your machine on the > Equipment Mart, bar menu on the left, that what > its for. > This is a technical forum for the SMT assembly > process. Try posting your machine on the
Electronics Forum | Fri Jul 15 10:34:28 EDT 2005 | dougs
how do you do it stephen? i'm interested to know what methods can be used to monitor a process such as this. is it best to set-up the wave machine parameters as russ and davef were talking about, what then, how do we know what effect a change in
.jpg)
Buyer, Seller, Broker of Electronic Assembly Equipment
Equipment Dealer / Broker / Auctions
309 West Pickle Alley
Rushford, MN USA
Phone: 507-864-7477
