Electronics Forum | Sat Oct 21 20:53:15 EDT 2006 | Ola
Of course. It has a dynamically programmable PLC. This means that you can program it into virtually whatever you want it to do, as long as it is within that particular conveyour specification. JOT doesn't normally give this "s/w manual" and "the han
Electronics Forum | Fri Dec 15 01:37:21 EST 2006 | shrikant_borkar
Hi, Hemendra Recently, We have carried out lead Free Soldering On our 4+1 Panasonic Reflow machine. Results were fine , but its Not Recommended for long Run. but the machine which you have is 5 zone machine and additional 2 cooling zone too. Check
Electronics Forum | Mon Dec 18 10:07:55 EST 2006 | rmitchell
Good morning everyone, Our IP3 head 1 is making a loud squealing noise, sometimes bad enough to hit the e-stop as it locks up. This started over the weekend so I don't have all the facts. When I manually move the Z spindle up and down by grabbing
Electronics Forum | Sat Dec 23 01:00:38 EST 2006 | mika
Of Course you can. We have a customer specific board that has a stupid connector underneith, and we must manually glue this one onto it's postition before reflow on the secondary side first... And as you know, the customers is alwayw left... The funn
Electronics Forum | Thu Jan 11 05:58:35 EST 2007 | Peter
Hi All, We again have problem with Zevatech FS-730 This machine shows error E202162: "System error: T axis of center head: Parameter error when T axis performs PTP action.(Kind of unit)" and it stop running. It does not pick up components. At low spe
Electronics Forum | Fri Jan 12 11:04:09 EST 2007 | mika
zero > in manual Control > bring the head close to the end of the machine so that you can reach the head => Diagnostic meny > engage the clutches and THIS IS VERY IMPORTANT: use Extreme Caution (you can flip off the X-Y circuit braker on the lower ba
Electronics Forum | Mon Jan 15 16:14:15 EST 2007 | leemeyer
This is a used oven, new to us. No product has been setup on it yet. We were establishing som baseline profiles and noticed that the actual profile read didn't even come close to our optimal profile. Further investigation proved that the belt was to
Electronics Forum | Mon Feb 12 10:06:46 EST 2007 | CK the Flip Guy
DaveF, Please define a "Cp/Cpk capable profiler." Do you mean one that has software that automatically calculates this for you? I do this at my company, and we track 2 critical variables - Time Above Liquidous and Peak Temps. and this is done on a
Electronics Forum | Wed Feb 21 14:10:36 EST 2007 | bobpan
The quad 1000 is best used for 0805 parts and larger. It is termed a chip shooter meaning 'for the most part' passives only. There is no optical alignment and it has mechanical centering using precisor pads. Fiducial finding is done with a beam and n
Electronics Forum | Thu Mar 01 23:15:28 EST 2007 | jmelson
You shouldn't be worrying about "impedance" on a DC relay. Just measure the resistance with a Voltmeter/Ohmmeter. If you need to know the current draw, it will be 24/resistance The impedance of an AC relay changes as the armature moves from the "off