Electronics Forum | Wed Dec 31 09:10:48 EST 2014 | rgduval
If you suspect a short, check the resistance on a new board that hasn't been powered up. The data sheet should give you the junction resistances that you're looking for. Double check against a component not assembled on the board. If you measure a
Electronics Forum | Tue Apr 14 10:36:03 EDT 2015 | bwest
We have a product which is supplied on 8mm tape. One customer recently commented that their SMT equipment couldn't handle the part as the tape was measuring 8.5 mm. Our actual measurements of this tape were 8.33 and 8.36 mm. I believe the max dime
Electronics Forum | Wed Jul 06 06:17:11 EDT 2016 | pavel_murtishev
Dear members, Recently we have found that solder mask thickness variation could lead to solder balling under QFN packages for a high reliability device. Is there any industry proven method for solder mask thickness checking? Any equipment or any me
Electronics Forum | Fri Sep 09 05:58:58 EDT 2016 | jswatt
yoru x-ray supplier should be able to help however you can do a rough cut calculation byt just printing it out and measuring it, your interested in ration (%) of the void and where in the joint it is to tell you it it's really an issue. Also importan
Electronics Forum | Thu Oct 13 11:19:01 EDT 2016 | chabscan
Hello, my fellow SMTnet users. I've been using my Quad 4C for some time now and I come to you with a question: What's the difference in the measurement of a leaded and a non leaded component, why does it have a different function for each one (FUNC
Electronics Forum | Mon Apr 17 14:43:35 EDT 2017 | davef
Measurement of Conformal Coating thickness on Printed Circuit Boards [ http://www.defelsko.com/applications/conformal-coating/printed-circuit-boards.htm ] I receive no benefit from the supplier mentioned above. IPC-HDBK-830A, 8.11.1 talks to measu
Electronics Forum | Wed Jan 30 00:56:00 EST 2019 | kiransahu
Sounds to me that the issue may be with vacuum and part of it, after the segment is put there's a little measure of air that pushes the segment far from the spout in MYDATA we consider it a kiss in my office, have you watch that the air that "puffs"
Electronics Forum | Wed Sep 04 13:40:46 EDT 2019 | smrsteve
Hello DWL, Thanks for the response. I've measured the components with a micrometer and set the sizes. Maximum tolerance on my machine is 20%, and that's what I'm using. If I do a manual scan, the measurements are exactly right (and what I've set up
Electronics Forum | Tue Jan 28 15:25:07 EST 2020 | emeto
If you refer to having wrong resistor or capacitor value, the only way is to automatically measure the part value. Mycronic pick and Place machines do it on the fly, ASM machines have feeder where part is measured....other main brands probably have
Electronics Forum | Wed Feb 12 15:11:29 EST 2020 | alvarez94
I was consulting the manual of the machine and to measure the tension of the x belt I need a frequency counter and two prisms but I don't have these tools, is there any other way to measure the tension?