Electronics Forum | Fri Jan 28 18:44:00 EST 2011 | rodrigo
Yeap, It did! Thanks.
Electronics Forum | Mon Feb 07 02:38:00 EST 2011 | rodrigo
No, thanks.
Electronics Forum | Mon Oct 24 16:10:07 EDT 2005 | Brian Davis, Compex Technologies
Dear Colleagues, We are looking at entry level AOI solutions. We are currently evaluating the Mirtec AOI MV-2HTL. We are also looking at Vitech because of their perceived "edge" in the industry. I know that this forum has approached this question be
Electronics Forum | Sat Mar 29 10:04:03 EDT 2014 | josse
Hello there everyone! Our company just bought an AOI Inspection Machine, and that is the Mirtec MV-2HTL 1.3 megapixel, software rev 4. I am trying to create a program that runs the top side first and then asks to run the bottom side consecutively. I
Electronics Forum | Fri Feb 04 18:41:26 EST 2011 | bdamico
Hello Rodrigo, I am sorry, but this is not the appropriate forum to discuss these matters. Please contact MIRTEC directly regarding your request (203)881-5559. Thank you, Brian D'Amico - President MIRTEC
Electronics Forum | Thu Nov 11 12:41:48 EST 2010 | rodrigo
What support options are there for someone that bought a used Mirtec AOI MV-2HTL? Thanks
Electronics Forum | Fri Mar 04 18:08:26 EST 2011 | eadthem
There is a option to enable no good marking that must be enabled on the board options where you reset your board count and images. dose the marker zero on startup?. If not then it may also need enabled in the inspector settings. ead
Electronics Forum | Sat May 14 12:32:33 EDT 2016 | dilogic
Depending on the vision, there might be issues with small black parts (like 0402 resistors etc.) - we have Mirtec MV2-HTL, btw.
Electronics Forum | Fri Mar 04 08:12:22 EST 2011 | pvasquez
Rodrigo, I have read a couple of your posts and it is obvious that you need some training my man! You should give the boys at mirtec a call and get yourself trained up. They have a really good support team. PV
Electronics Forum | Fri Jan 28 14:58:00 EST 2011 | hegemon
When reviewing the defects, I believe you can select the part, right click on it, and select "create new frame". This would create a new frame with that part alone in it, and centered. Better inspection for that part. Possibly this won't work with