Electronics Forum | Wed Oct 29 18:18:34 EDT 2014 | jorge_quijano
Hola Grayboard, I've had the same situation with these components, I changed the stencil apertures a little bit and use a stepped stencil (5-6mil), after some trials we were able to get decent yields, but we still had some failures, what we discover
Electronics Forum | Wed Aug 03 13:04:04 EDT 2022 | proceng1
My initial thought is that the part is slightly delayed in releasing. When you are running one head, it doesn't matter. But when running multiple heads, the machine starts to move to the next placement before the part has fully released from the noz
Electronics Forum | Tue Oct 28 17:15:46 EDT 2014 | grayboard
Hello, I am looking into the use of a Samtec SEAM-50-02.0-L-10-2-A-GP-K-TR on a board. Is anyone around who has experience with this component? Specifically, we are looking for design advice for stenciling and soldering. The component is a sold
Electronics Forum | Fri Oct 26 13:16:41 EDT 2018 | slthomas
Is there any chance that something like a riv-nut might be used for mounting purposes or is it just a screw hole?
Electronics Forum | vsuresh |
Mon Apr 15 11:48:14 EDT 2024
Electronics Forum | Fri Oct 26 05:03:17 EDT 2018 | farouk225
Hi everybody, I have a question about the minimum distance to leave beteween a non non-plated mounting hole with copper pads and the edge of the PCB. Is there any formula or rule to apply ? For example for a hole of diamater equals to 5.6mm which
Electronics Forum | Fri Oct 26 12:29:22 EDT 2018 | davef
I'm not aware of a standard requirement. One screw hole diameter seems to used commonly.
Electronics Forum | Mon Apr 15 16:33:37 EDT 2024 | cyber_wolf
Unskip part npm1 or take npm 1 out pass thru mode
Electronics Forum | Tue Apr 16 20:38:03 EDT 2024 | digitalshovel
when in assign mode, set npm1 as pass. The condition set will make it pass through to npm2
Electronics Forum | Wed May 01 11:47:44 EDT 2024 | linux
Panasonic provide several courses beginners to advance. Not very expensive
