Electronics Forum: mpm ap 25 hie (Page 1 of 22)

ap25 hie

Electronics Forum | Sat Oct 15 19:18:14 EDT 2011 | enttec

Hi Does anyone have a calibration manual for a MPM AP25-Hie ? Have noticed recently that we have a slight mismatch between board and stencil when printing. I have the user manual but we didn't get calibration when we bought this machine Thanks Nic

ap25 hie

Electronics Forum | Mon Oct 17 18:08:04 EDT 2011 | enttec

DOS

ap25 hie

Electronics Forum | Mon Oct 17 18:01:42 EDT 2011 | swag

DOS or Windows NT?

ap25 hie

Electronics Forum | Tue Oct 18 17:54:53 EDT 2011 | swag

Yea, it's tough and takes 25 disks. Not sure if there's a better way. As for NT, we bought NT upgrade packages from Speedline for all three of our AP25's. The backup is then done on a CD burner. I can't remember the cost of it all. However, be a

ap25 hie

Electronics Forum | Mon Oct 17 16:24:10 EDT 2011 | enttec

Hi Thanks for the reply, which files contain this info ? I've searched around in the filesystem and can't find them

ap25 hie

Electronics Forum | Tue Oct 18 17:38:03 EDT 2011 | enttec

Hi Thanks for the info, I'll try that. Can you tell me more about the NT conversion ? Our operators sometimes struggle with doing backups and such on the dos system Thanks

ap25 hie

Electronics Forum | Mon Oct 17 10:14:32 EDT 2011 | swag

Do you have cal. fixture(s)? If not, one 1/2 baked way to get yourself closer quickly is to go into your programs and write down your x/y offsets that you've gained during vision offsets while in production. Compare them - hopefully they are very s

ap25 hie

Electronics Forum | Tue Oct 18 10:07:59 EDT 2011 | swag

We converted all ours to NT so it's been a long time since I did config changes in DOS. Here's what I think I remember from when we had DOS O/S: Exit to DOS and type CD CONFIG in the command line. You should get a full list of configuration settin

Camera not parked error on mpm ap 25.

Electronics Forum | Mon Jun 12 10:38:00 EDT 2017 | highmillr

Getting this error more frequently. Whats causing this?? I have to reset machine every time costing man hours. After resetting its fine but does it at least once a day.

Camera not parked error on mpm ap 25.

Electronics Forum | Mon Jun 12 23:52:58 EDT 2017 | aemery

Don, either you have a faulty park sensor or much more likely the vision gantry Y axis is not reaching the sensor. Possible issues, one of the two VY drivers cards is failing; one of the VY forcer motors (air bearings) is failing; to much air leakin

  1 2 3 4 5 6 7 8 9 10 Next

mpm ap 25 hie searches for Companies, Equipment, Machines, Suppliers & Information

Flux-Free Reflow Soldering

MSD Dry Cabinets
2021 IPC Training Schedule

Best Reflow Oven