Electronics Forum | Thu Sep 28 01:30:32 EDT 2006 | fastek
Todd- In light of the reply from an obviously confused Darren, an IP would be a fine "line balancer" in conjunction with your MY-12. Your choice of either an IP-1, IP-2 or IP-3 should be based on the type of components you want to run. You mentioned
Electronics Forum | Tue Oct 17 21:59:47 EDT 2006 | jovial_guy23
Hi Steve, I agree with you that cleaning under LCC's is often difficult but its not impossible. In order to clean the residues, the most important thing to consider is the right compatibility of the fluxes with the cleaning chemistry. There are seve
Electronics Forum | Tue Oct 03 22:10:42 EDT 2006 | jonatf
Hi guys, Our vapour phase oven is taking too long to heat up about 15 mins/cycle. Normally its 5 to 6 mins. 2 reasons why. 1.using 10 amp power board 2.heating element not working properly. before i set up a 15 amp outlet i want to know first if my
Electronics Forum | Mon Oct 16 10:07:11 EDT 2006 | realchunks
Wow, 15 degrees C is too much. Is this a new problem or new oven? If it's a new problem several things you can check out. Thermocouple placement may have got knocked into the wrong spot, or it could be dirty. I've seen this happen after a PM and
Electronics Forum | Tue Oct 31 15:45:17 EST 2006 | dman97
Does any one know where to buy spare parts for an MPM UP1500, other than from Speedline themselves? I need to buy replacement foil clamps for my machine, but MPM wants $393 each! It is just a piece of foil, a sharp one at that. I ain't going to spend
Electronics Forum | Thu Nov 09 22:21:18 EST 2006 | John S.
I would think it would be more productive to compare DPMO. Particularly across different products. A simple board of 20 components should yield much higher than a complex board of 200 components. Also, some consideration should be given to the dif
Electronics Forum | Tue Nov 14 03:48:08 EST 2006 | aj
Hi, What is the non-leaded part ? the only real obstacle I have found is when using a Leadfree BGA with PB Paste. We have had to do this in the past - the hybrid profile I used was pretty much the same as normal apart from increasing the peak temp
Electronics Forum | Tue Nov 21 12:04:52 EST 2006 | Rob
From what I remember it was kind of obsolete before it started as the CP6 came along shortly afterwards & we all know how great they still are. It didn't offer much more than the CP4's so it was kind of squeezed out. I do remember hearing of one
Electronics Forum | Thu Nov 30 16:31:40 EST 2006 | techgonecrazy
This has been a problem from the start. I used a digital flowmeter to check exhaust and both sides are pretty even, however, I do not know if its exhausting too much or not enough, just going on the PE specs...but then again...do they really know. I
Electronics Forum | Thu Jan 25 12:06:13 EST 2007 | wagoner
We are an OEM and we were about 75% converted to lead free. Very few of our customers showed any interest in ROHS compliant products and none of our competitors were doing it either. We had a few field failures that may have been related to the hig
winsouce.jpg)