Electronics Forum | Mon Oct 21 09:41:42 EDT 2019 | mendezt6
Update: -The A12 tools will install in the 2nd machine. -Modified an A12 tool to install in the A13 tool location. -The modified tool will install in the A13 location of the 2nd machine, but not the 1st machine. Check that the parameters o
Electronics Forum | Tue Oct 22 21:24:02 EDT 2019 | richgreen01
Hi All I have the above machine and every day on start up i get the failed to initiate hardware message.I have been getting around this by re initiating the motor controllers and it is good to go after this.Does anyone know the causes of the initiat
Electronics Forum | Wed Oct 23 10:22:55 EDT 2019 | maxwilko
Hey Kathy, Thank you for the link for the tech support will keep that in mind for the future! After a long series of testing different solutions we found that re-sending the Gerber data over to the 'My500' seems to have resolved the issue, we are n
Electronics Forum | Wed Nov 11 11:50:19 EST 2020 | paulanderson
An update. I managed to resolve the issue by wiring my own :) got a friend with a UK spec MY12 to take pics of the internal connections of theirs and then hard wired ours to match - worked perfectly. message me if you have a similar problem and I ca
Electronics Forum | Wed Feb 12 15:11:29 EST 2020 | alvarez94
I was consulting the manual of the machine and to measure the tension of the x belt I need a frequency counter and two prisms but I don't have these tools, is there any other way to measure the tension?
Electronics Forum | Fri Mar 06 14:33:53 EST 2020 | bk
Another thing you can check is where the bar comes down off of the hydra z motor there is a little bearing you can see from the front make sure that bearing is turning even oil it up a little. You can also adjust the tension by loosening the tiny set
Electronics Forum | Fri Mar 06 19:32:09 EST 2020 | SMTA-Alex
The fact, that your Hydra head goes up and then starts moving slowly, means that it didn't find the limit. Since there are no mechanical obstructions and you swapped all the boards, the things to look at are cabling. Double check the ribbon cables fo
Electronics Forum | Mon Apr 06 14:02:05 EDT 2020 | tomdegas
I have tried that Tim and I get the same error message. Originally it would pass in the service menu but when I switched back to TPsys, it would fail. I tested the friction one time it did pass and it was well withing the range. Thanks for the res
Electronics Forum | Mon Apr 06 17:08:30 EDT 2020 | tima
Try swapping XWB board that is on top of X-Wagon. Have you try that? All signals go thru there. Another thing can be those 2 ribbon cables that are behind of X-Wagon. How long ago did you change them? What I would do is to move X to different positio
Electronics Forum | Sun Feb 23 14:29:30 EST 2020 | midast
Hi We are looking on buying a used MY19. When comparing, the TPSYS version seems to be a major thing. What is TPSYS? Firmware? OS Version? How much does a TPsys upgrade cost? Is it something I can do? Can TM8 feeders handle 0402 reliably? I saw th
