Electronics Forum | Wed Jun 01 22:42:50 EDT 2016 | dinhhuunam
CAN Node Not Responding This problem can be caused by either: 1. Faulty Node 2. CAN bus cable disconnected. 3. No power to CAN Node.
Electronics Forum | Mon May 30 20:17:54 EDT 2016 | jasltd
Hi Folks, I'm having issues with our dek Galaxy which is randomly having and reporting the error CAN Node Not Responding. Has anyone seen / fixed this error before?
Electronics Forum | Sun Jan 16 16:51:23 EST 2022 | silverlead
Chapter 7 - Machine Control of the DEK manual outlines connectivity between the rising table servo node 6 and the NextMove ES card. If you don't have the manual, just PM me. I'm not an expert in DEK repair, but the solution could be as simple as clea
Electronics Forum | Thu Jun 02 04:20:58 EDT 2016 | jasltd
Thanks, I have managed to get a step further and now get the additional info on the error that it is node 1. All cables are connected, will double check the power but I believe it has power, I seem to be able to drive everything in diagnostics mode
Electronics Forum | Sat Oct 03 06:01:38 EDT 2015 | gafur
yes i've...main I/O node 2 already swap with other dek horizon machine...the result is good...
Electronics Forum | Thu Jun 02 08:45:41 EDT 2016 | emeto
If it is intermittent it is definitely cable or connector. Check all connections first and if not, replace the cable that is moving/bending.
Electronics Forum | Fri Oct 02 21:40:49 EDT 2015 | gafur
hi all...please give me advice..my machine dek horizon 03ix error can node machine I/O...thank's before...
Electronics Forum | Thu Dec 22 17:59:39 EST 2022 | emanuel
Thanks Jeff, Yes, I will be glad to know which parts you replaced, at least it will give me an idea where to start looking. I also have a feeling that being the first node, the BGE9010C if not working properly may distort the CAN Bus signal. I even t
Electronics Forum | Thu Dec 22 11:18:59 EST 2022 | emanuel
I am interested to know if you solved this problem. We are experiencing something similar. The table is the first node in the CAN chain. As I see the structure, the CAN starts from the Nextmove ES card, goes first to the table driver and continues to
Electronics Forum | Thu Dec 22 16:59:39 EST 2022 | goseese
My problem was the BGE9010C. Any time there was any pressure on the rising table the error would occur. I was not able to find a replacement BGE9010C so I opened it up and found some blown components. Replaced them and the problem was solved. I "
