Electronics Forum | Fri Feb 28 08:57:34 EST 2003 | davef
We used to bake [100*C for 6 hours] all of our boards, but no longer bake at all. Before going off, your bake recipe is probaly OK. If anything, it's probably too short. Consider measuring the weight of wet boards, baking for a time, measure, bake
Electronics Forum | Wed Apr 16 13:19:13 EDT 2003 | Takfire
Thanks Russ! The origianal complaint from the customer was in regards to what appeared as "bumpy" appearance and "holes" in the solder fillet. This problem was originally presented as an appearance issue only. Further investigation by our DPA lab r
Electronics Forum | Tue Aug 04 17:37:43 EDT 2009 | gregoryyork
Im not sure that 0.004% is that critical in a solder alloy. If people are using our alloy and the Nickel increases we would most probably suggest running a dopant alloy without Nickel to bring the levels back down, it is very rare to require dumping
Electronics Forum | Wed Mar 11 17:32:46 EDT 2015 | jlawson
Small paste deposits have less flux thus less flux activity to enhance the wetting. So preheat needs to be as short as possible, ramp to spike if possible. Try not to ramp hold and spike - pending thermal delta on product can be made to ramp to spike
Electronics Forum | Thu May 17 07:36:40 EDT 2001 | Bob Willis
Here is a copy of a draft document on PIHR Inspection I have jotted down on a flight to Scotland yesterday, any comments suggestions etc ? I have already most of the photos for the standard but as you know there is nothing in the IPC document it just
Electronics Forum | Sat Feb 05 09:08:18 EST 2000 | Dave F
Casimir: Let me expand on something that I said in my response to your thread on ionic testing. Generally, no-clean people don�t use ROSE testing as part of their process control, because the ROSE test is essentially washing your board in DI/IPA �
Electronics Forum | Mon Aug 17 02:57:47 EDT 1998 | Bob Willis
| | Looking for Suppliers of surface mount wetting balance equipment. | Bucky: Section 6 of the ANSI/J-STD-002 specification lists wetting balance suppliers. Dave F I like and continue to use the Multicore system. I have had many ours using the sys
Electronics Forum | Wed Jun 30 08:58:59 EDT 1999 | M Cox
| | | | snip | | | | | John and Dave, | | | | | | Again, I don't work with larger chip devices with this issue. The company I now work with developed a strategy, based on considerable research (as others of us did in the past), to do things like p
Electronics Forum | Wed Jun 30 09:33:11 EDT 1999 | Earl Moon
| | | | | | snip | | | | | | | John and Dave, | | | | | | | | Again, I don't work with larger chip devices with this issue. The company I now work with developed a strategy, based on considerable research (as others of us did in the past), to do t
Electronics Forum | Mon Jun 25 20:39:08 EDT 2001 | ianchan
Hi mate, no complete info given from what i see, so just some humble comments, mayhaps you review : 1) PCB pad finishing - Copper+nickle plated? coz if so, nickle is a KILLER to good solder wetting. what we did back here, was to HAL coat the nickle
winsouce.jpg)