Electronics Forum | Tue Sep 05 14:40:08 EDT 2017 | rgduval
We emailed off forum about this...and I'm wondering how things are progressing. As I noted in email, our issue was the nozzle change was resulting in too many nozzles being out of the same vacuum channel on the tool box. I can't remember how it was
Electronics Forum | Sun Sep 01 22:02:58 EDT 2019 | sarason
Have you got a circuit diagram for your driver board? If not measure your driver into a resistive load and look for differences in current flow voltage drops under load dried out caps. Dead current measuring circuits etc. If you see an IC, look it up
Electronics Forum | Tue Aug 27 02:55:43 EDT 2019 | oxygensmd
I am looking for a simple software which I can use in my production. I have the following task which I would like to solve with this software: - Components storage: counting the components in my production area. I would like to store their following
Electronics Forum | Fri Sep 27 13:34:34 EDT 2019 | tey422
We are to install a very small BGA socket, the datasheet noted to be torque the M1.6 size Phillips screw to the spec for installation. I couldn't find the correct size bit that would fit our torque screwdriver. Per the screw size, shouldn't it be PH0
Electronics Forum | Fri Nov 22 10:24:28 EST 2019 | rgduval
When you swapped the MOT card, did the proble move to another axis? I'm guessing no, but, wanted to clarify. If the problem did not move, you either have an x-motor problem, x-motor counter problem, or x-transducer problem as noted. Or, a cable pr
Electronics Forum | Tue Feb 04 09:21:48 EST 2020 | nhusa
There are two areas that are important when discussing cooling rate. One is the rate thru the liquidus, where a fast rate produces small grains in the metal and a slow rate results in larger grains. Although smaller grains are stronger normal SM
Electronics Forum | Mon Aug 17 15:19:16 EDT 2020 | jmelson
I have a (new to me) Quad QSA-30A that I just got about a week ago. At first, I could get it to go ready most of the time, now it will never go ready. I have traced the ready button into the DPRAM board and the logic is OK all the way into one of t
Electronics Forum | Sat Feb 13 08:03:14 EST 2021 | dilogic
I might answer some of your questions: 1 - in order to use old 24V feeders, Advantis needs 24V feeder kit installed. As far as I figured out, it's only 24V transformer and wiring, so I guess you can do it yourselves if the machine is not upgraded
Electronics Forum | Wed Feb 23 13:22:31 EST 2022 | micropak
Congratulations on being operational again... Few years ago, I acquired a Siplace line (S20 + F3 + S15 + G2) and I rebuild it completely because the line was lying idle for more than 10 years. All belts, pneumatic cylinders, pneumatic pipes were cha
Electronics Forum | Thu Jan 12 16:53:59 EST 2023 | SMTA-67037450
I need to benchmark or sanity check our incoming inspection process in relation to IPC Class 3 electronics. I am looking for a contact with someone who assembles/builds IPC Class PCBAs, that i can sanity check some stuff with. To start, our process