Electronics Forum | Tue Oct 10 12:34:43 EDT 2006 | bobpan
Larry, Do a runstep nozzle then open the door and look and see if the nozzle is all the way on. Push up on it and see if it moves up
Electronics Forum | Tue Oct 31 23:46:12 EST 2006 | fastek
Which nozzles are coming up NG on the large camera? If it's the smaller ones, don't worry about it. Those nozzles don't use the large camera anyways. Be concerned if the small nozzles are coming out NG on the small camera.
Electronics Forum | Mon Feb 05 12:57:35 EST 2007 | cyber_wolf
Take the nozzles out and let the indicator tip touch the metal face the nozzle pushes up into. This will tell you whether the variation is in the shaft or the nozzles. Also while your indicator is touching the holder, manually grab the shaft assy a
Electronics Forum | Mon Feb 19 07:31:43 EST 2007 | jax
Check the nozzle. If these are the only two parts on the board that use a specific nozzle, it's a good place to start. The nozzle is probably not releasing well and shifting the component when trying to retract after placement...
Electronics Forum | Fri Mar 23 07:17:50 EDT 2007 | Phil J
Stefan The Z hight required for a MELF will depend on the design of nozzle used on your machine. If it has a "V" tip you should measure the hight of the component on a nozzle then subtract the nozzle hight.
Electronics Forum | Fri Dec 19 09:35:39 EST 2008 | ronniewong
We made the best nozzles. We made all types of nozzles in Singapore, contact us avipre@avipre.com.sg, http://www.avipre.com.
Electronics Forum | Sat Aug 02 16:05:08 EDT 2008 | Frank
Custom made nozzles from our vendor of pick'n'place machines are a bit on the expensive side. Does anyone have any recommendation of third party companies, or a good quality machine shop, that may be able to make us a couple nozzles?
Electronics Forum | Wed Jun 02 11:39:02 EDT 2010 | emrtech
so, i found a new tool tip nozzle for the my9 to place the 0201 components and works perfect. the tool tip is also made out of stainless steel. the nozzle was completely modified and works alot better than the OEM nozzle.
Electronics Forum | Mon Jul 26 14:16:54 EDT 2010 | jdengler
I don't find this P/N in my list of 2.5mm IP2 nozzles. But we buy from and have bad nozzles repaired by SMT Researh. www.smtresearch.com Jerry
Electronics Forum | Mon Jul 26 18:27:59 EDT 2010 | fredc
We make these also. Our nozzles are available as medium hard from heat treated bar (32 to 38RC) or very hard made from Bearing Quality 416 stainless. We can retip your Fuji nozzles also. www.nozzlesupply.com
SCANSMT is local stocking dealer who major in SAMSUNG,PANASONIC,YAMAHA,JUKI,FUJI mounter and MIRTEC,KOHYOUNG,PARMI,PEMTRON,CYBEROPTICS AOI&SPI,MPM,SJ,ESE Printers.HELLER,TSM Reflows are always have invertonries.welcome to visit us
Training Provider / Manufacturer / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
Floor 1,D Building,B area,Dongsheng Techwin Park,Bao'an District
Shenzhen, 30 China
Phone: 008618566662725