Electronics Forum | Wed Apr 13 08:56:39 EDT 2005 | Dhanish
Hi, I need help as we are seeing high defect on label peeling off which is attached on the PCB.After remove the liner on the Lexan label,we realize there is crack in the adhesive and base materialPlease advise what test can be done to ensure there is
Electronics Forum | Mon Apr 18 11:26:38 EDT 2005 | davef
Whenever we hear "gold" and "balls falling off", we think of black pad [hypercorrosion of nickel]. What does your EDX show?
Electronics Forum | Thu May 26 05:46:14 EDT 2005 | ajaydoshi
What is the exact error message? or error code? Machine stop ramdonly. No error code if try to reset error it show T , turn power off. then turn off power . start again. set cam angle manually to origion & start. thanks ajay
Electronics Forum | Wed May 25 12:12:26 EDT 2005 | Dave G
3M jetmelt. A bit better than off the shelf reg hotmelt. Also use a GE white RTV. Never had any caps come off the board with either. DG
Electronics Forum | Thu Jun 16 07:55:35 EDT 2005 | mmjm_1099
Buy ESD safe gloves cut the fingers off and fill with buckshot and use plastic tie wraps to tie them off. No the tie wraps will not burn.
Electronics Forum | Thu Aug 18 13:11:39 EDT 2005 | jsloot
We have our board house apply a peel coat mask that can be brushed off after wave or reflow. You need to brush off while it's still warm.
Electronics Forum | Mon Aug 22 09:34:54 EDT 2005 | Lee
i need documentation on off-line progrmming for fuji cp-642e can any1 help me?
Electronics Forum | Thu Nov 03 18:20:15 EST 2005 | JG
Dek 265 GS Problem: Machine abruptly turns off. It can be in the middle of a stroke or just sitting idle. After the machine turns off we have to let it sit for a few minutes (sometimes 20) in order for it to restart. Any suggestions? Thanks in adv
Electronics Forum | Tue Jan 31 02:59:18 EST 2006 | jgarver1
You also should check to make sure you have blow off at the placing station set properly. I have seen machines with the flow control valve shut completely off not release parts properly. The parts end up in the scrap bin and the machine thinks they
Electronics Forum | Mon Jun 12 14:33:40 EDT 2006 | pjc
IPC spec is V-score shall not be more than 1/2 board thickness. They should be V scoring 1/4 off top and 1/4 off bottom equally.
