Electronics Forum | Fri Sep 16 14:51:06 EDT 2011 | isd_jwendell
I recently did a layout for a Freescale accelerometer and the mfg recommended pad layout did something similar. They where very specific in the pad layout dimensions. They stated the reason was "With the correct footprint, the packages will self-alig
Electronics Forum | Wed Mar 20 20:33:03 EDT 2013 | garym4569
Just my 2 cents. If you just added a line, then obviously your volumes were too much for one line. I would definitely consider purchasing enough feeders and reels to be able to run both lines at the same time. You would probably offset the extra i
Electronics Forum | Mon Mar 25 20:02:05 EDT 2013 | hegemon
Thats a good one Dave. Sorry to say, but I have seen setups very similar for the mass repair of Playstations. Just add a heat gun over the top and you are ready for some rework! . And just LOOK at the controller! With E-Z turn knurled knob for setti
Electronics Forum | Thu Oct 02 15:34:08 EDT 2014 | arifa_anees
the data collected from a standard SMT process is typically very noisy due to the natural.Initially, the most common evaluation method was placement yield.Offset Placement After Solder Screen-printing can reduce or eliminate these defects through cor
Electronics Forum | Tue Mar 10 10:25:37 EDT 2015 | menvox
Hello, I have a Juki 750L with a damaged hard disk. I need the machine software. If somebody have it, or a mirror copy of the hard disk.. Did somebody know where is located the offsets and setings of the machines? On the hard disk or on the computer
Electronics Forum | Fri May 29 14:19:14 EDT 2015 | dekhead
Offsets are there to for an alignment change over the entire board... alignment weighting is, essentially to account for imperfect match between stencil and board, and will allow you to concentrate best alignment to a given portion of the board (give
Electronics Forum | Tue Jun 09 14:10:41 EDT 2015 | duchoang
Last time I used Topaz X2 was 5 years ago. Correct me if I'm wrong. There are some reasons: -Head dirty so machine thought there was nozzle on head already. -Nozzle changer/ Nozzle position offset. -Something jammed and nozzle changer can not go all
Electronics Forum | Thu May 26 09:21:37 EDT 2016 | bobpan
Everytime I have seen an offset like that it was dirt on the quad-align lens.....try cleaning it off with alcohol and a lint free cloth. If this does not fix it....you may have dirt inside the quad align itself. I am assuming you have checked to ma
Electronics Forum | Wed Jun 08 12:30:38 EDT 2016 | deanm
Lead forming can provide retention during wave soldering. There is the simple offset method, the dimple and compound forms. All of these are outlined in IPC-AJ-820A. It would probably require automated lead forming equipment using special dies. GPD m
Electronics Forum | Mon Feb 20 04:57:51 EST 2017 | ariss_t
Hi Peter.. Pls make sure u tick the inkspot box inside the sipro.. when u do this pls make sure the cam cross bullseye really near the inkspot center point.. then u need to teach the good inkspot and bad inkspot.. seems like ur inkspot position offse