Electronics Forum: omni and installation (Page 1 of 11)

SPEA 4040 installation and training

Electronics Forum | Tue Aug 31 09:58:33 EDT 2010 | cardinal

Hello, I am looking for someone who can do complete installatin and training on a 2005 vintage SPEA 4040 flying probe system. We are willing to pay top dollar for this service; please contact me if you have interest in this job. Future opportuni

Dye and Pry

Electronics Forum | Thu Mar 13 01:42:58 EDT 2008 | Sean

Thanks Real Chunks and Davef...Yours input is valuable to me. My inputs towards your question asked below: Questions are: * Why did you tell us the following? "This BGA is installed with heatsink (with hook at both side of the heat sink) manually b

Dye and Pry

Electronics Forum | Wed Mar 12 23:00:10 EDT 2008 | davef

You can say: The pad was lifted after reflow and prior to the dye and pry failure analysis. When we see lifted pads, we think: * That's a good solder connection * Either it took a lot of force to lift that pad or the fabrication of the board in the

QSoft2 and Sound output

Electronics Forum | Sat Jun 14 09:28:27 EDT 2008 | torch

im currently trying to get the audio responses working with QSoft2 as our machine didnt come with a soundcard ive managed to find an old ISA card and get it installed. its a creative soundblaster so quite a well known brand and easy to install, win98

small and good pick and place machine

Electronics Forum | Thu Sep 05 23:18:03 EDT 2013 | feiyangniao

There is a new toy I received today: a NeoDen TM-240A automatic desktop pick and place machine! I’ve kept my eyes on this baby for a quite a while, and finally decided to make a purchase last week. The shipping was very fast: DHL from China, a total

High-end SPI and AOI?

Electronics Forum | Tue Oct 13 16:11:44 EDT 2009 | mikesewell

Not sure how many inspections need to be done at 15 - 20sec total per board, but you may need to install multiple SPIs/AOIs to hit your takt time. Mike

Manncorp Pick and Place

Electronics Forum | Thu Jul 31 13:44:07 EDT 2014 | budro

Does anyone have experience with Manncorp equipment? I’m evaluating equipment to install a mid-level production line, and Manncorp was suggested to me to consider. Other equipment I’m considering are Essemtec and Mydata. Any input would be appreciat

Wave flux and profiling

Electronics Forum | Mon Dec 18 13:00:47 EST 2006 | grantp

Hi, We have a white residue, which is visible, and we would like to have the produce clean as it's a PCI card, so users see the PCB. I am wondering if we need to install a cleaning stage to the line for these kinds of products. Can anyone give som

Dye and Pry

Electronics Forum | Wed Mar 12 07:33:40 EDT 2008 | callckq

Hi All, One PCBA failed test after went through the Shock Test(Vibration) and suspected to be BGA solder ball crack. We performed dye and pry and found PCB's pad lifted with red mark ink penetrate pad underneath, what does this mean? Can I say the

Manncorp Pick and Place

Electronics Forum | Tue Aug 05 21:08:10 EDT 2014 | isd_jwendell

You are correct about the Manncorp machine, it was an MDC machine. The Essemtec machine is old(ish) but still runs fine, and last I knew they were still supporting it. My recent problem with Essemtec was in regards to software. I found a bug and sim

  1 2 3 4 5 6 7 8 9 10 Next

omni and installation searches for Companies, Equipment, Machines, Suppliers & Information