Electronics Forum | Sun Sep 13 18:45:24 EDT 2009 | halleyjoan
Is there any possible way to repair the blower of vitronics reflow oven if it stuckup? How to replace its blower? Or i should be replaced as 1 assembly (cell motor and blower assembly).
Electronics Forum | Tue Sep 15 05:11:52 EDT 2009 | srinivasa
hi, if the blower is stuck, check the pully shaft whether it is correctly fixed with fans. if price is concern, you can remove the motor and get it repair by re-winding of motor coil. if price is no concern you can change complete assemly or motor a
Electronics Forum | Mon Sep 01 04:55:20 EDT 2008 | benefon
Hello all Our Omni 5 has given the 'Cooling module high temp' warning twice during the past month. I suspect that the blower motor is the culprit but have not been able to verify this because the oven has started up normally after acknowledging the
Electronics Forum | Wed May 30 19:08:58 EDT 2007 | darby
Mark, You should find that the blower motors and heaters will be replaced free of charge by Heller. I have four Heller ovens and have found that to be the case. I am the original purchaser however and it may be different if you have purchased the mac
Electronics Forum | Wed Sep 03 07:39:19 EDT 2008 | pjc
You may not be getting enough exhaust pull, so the cooling modules over temp. Try swapping blower motors to isolate that before buying one. STANDARD AIR OPERATION: - Load-end: 150 cfm (255 m3/hr) at the 4� (102 mm) stack (minimum requirement) - Unlo
Electronics Forum | Thu Apr 15 01:29:35 EDT 2004 | pyro747
Hello Everyone, I am having a pin chain speed problem. The speed of the chain will slow down after start up of the oven. Example if you set the conveyer to run at 41 in/min, as the oven warms up of conveyer will slow down phycally but won't chan
1 |