Electronics Forum | Wed Jul 08 03:43:27 EDT 2015 | pmcg
I'd also be interested in seeing what the OP went for too. We're thinking of upgrading our MPM3000 series. Has served us well over the years but is a bit dated to say the least. Not heard much about the SJ Inno. machines here in the UK. Would prob
Electronics Forum | Fri Jun 28 21:09:56 EDT 2019 | joseangulo
Hi everyone, So basically i have a Wave optimizer (Model: SW-op) And after it finish to take the information from the wave, It show L Contact Lenght 0.00 CM and R Contact lenght 0.00 CM Any idea what can i do to solve this problem? Thanks
Electronics Forum | Sun Mar 12 13:49:09 EDT 2023 | phuongvbhp
Hello everyone I am having Chip loss error at Line SMT, Mounter Panasonic , component type 0402,0603. The positions are not the same and the ratio is around 7/1000. I suspect the chip was dropped during the PCB move behind the mount. The OP's operati
Electronics Forum | Wed May 09 01:40:55 EDT 2001 | Dreamy
Hi Michael, DPMO Index calculation - The total number of defects (Dc + Dp + Dt) on a completed Printed Circuit Board divided by the total number of defect opportunities (Oc + Op + Ot) for that PBA multiplied by 1 million. Your calculation deals only
Electronics Forum | Mon Feb 07 11:05:50 EST 2000 | Graham Naisbitt
Dave You are so right about that point. I still use some cost models we ran up some 5 years ago. I took one to a customer and showed them that they could make $400K more PROFIT PER YEAR running OA v No-Clean. Their response? Well, we don't believe
Electronics Forum | Wed Oct 09 08:56:42 EDT 2002 | pjc
If I understand your question: I've done this before by creating a spreadsheet in Excel. All the data you're looking for can be built into said spreadsheet. I don't think you'll find a "canned" package with the values without buying a bigg-ass prgram
Electronics Forum | Sat Mar 06 22:26:34 EST 2004 | Ken
I think it is a good idea to "waste" money on this analysis. Especially if you phase in a SAC wave alloy. Silver is not toxicity free....and lead free waves can dross 3 to 5 times faster than SnPb alloys. This produces a greater potential for airb
Electronics Forum | Mon Jul 19 12:57:59 EDT 2004 | Frank
Awhile back there was a thread here about needing to pick a BGA-type component that is dead-bug (ball-side up). The OP was looking for a special nozzle tip that will conform around the balls in order to pick the component. There were a few response
Electronics Forum | Wed Jul 27 22:43:10 EDT 2005 | crishan
Hi all, Having a major problem with an IC being placed upside down. We pick up the fault at AOI. We have check several reels and the component is not placed upside down by the supplier. Where should I start looking; 1. Are we using an incorrect fee
Electronics Forum | Fri Jun 22 11:09:01 EDT 2007 | realchunks
Sup G! Normally when spray fluxers get neglected, the spray pattern is the first thing affected. To actually 'see' this, we cut out a piece of cardboard the same size and length of the board. Run it over the fluxer and then turn itover and look at
