Electronics Forum | Thu May 21 12:53:38 EDT 2020 | spoiltforchoice
A cheap piston compressor (like you might use in a garage) should be rated such that it has ~50% duty cycle, you don't want it running continuously. They are very affordable but do switch on and off between two essentially hardwired setpoints. The b
Electronics Forum | Mon May 25 20:51:13 EDT 2020 | kylehunter
> A cheap piston compressor (like you might use in > a garage) should be rated such that it has ~50% > duty cycle, you don't want it running > continuously. They are very affordable but do > switch on and off between two essentiall
Electronics Forum | Wed Jun 24 14:42:03 EDT 2020 | kumarb
Hi. Heck no! First, you should find out the Yamaha equivalent of your machine, if known - that is a more common reference when sourcing parts. While we have no affiliation with the vendor other than a very positive history of sourcing a laundry list
Electronics Forum | Wed Jun 17 17:53:48 EDT 2020 | aveazey
We've got a GSM1 running OS2/WARP version 4.5.0 and we ran into having placement issues for all components. Each placement seems to be exactly 30 mils offset from it's actual location. We've got a 2.6 mil/px and a 4.0 mil/px camera. Attached is an
Electronics Forum | Tue Jun 23 21:48:06 EDT 2020 | jmelson
I don't know much about Essemtec, I have been looking at Neoden a little. At least the Neoden is not in any way in the same class as machines like Assembleon or Samsung. I did download the manual for a Samsung CP45FV NEO, and the programming side o
Electronics Forum | Mon Jun 29 15:45:20 EDT 2020 | spoiltforchoice
Yeah my issue with the CLM945 type single slot feeders used for parts over 6mm is they index forwards using a tiny servo attached to some gears that pull on the cover tape. A system that begs to fail, the tape can stretch, the gears can start grabbin
Electronics Forum | Tue Jun 23 22:19:33 EDT 2020 | kumarb
Hi. Have an older 1809EXL that was purchased new and has sat idle for years with 270 on hours as of today. After days of testing, unable to melt fresh paste from Loctite (SAC305). The root cause after the investigation is due to one of the 2 TDM modu
Electronics Forum | Thu Jul 02 01:56:01 EDT 2020 | hudsonhock
Hi, I've been using Fabmaster in my daily job scope for 10+ years. Currently I'm using version 11.0.0.70, there's two issues noted in this version and would like to check if any workaround on this. 1. Fabmaster would crash (terminate) intermittent
Electronics Forum | Thu Jul 23 13:23:45 EDT 2020 | bmalhi
Small components blown issue could be due to one of the below. - Process issue; Make sure solder paste is fresh, if flux is drying out it will not hold parts properly. Check downward pressure of Pick Place. SOT may have to be pushed a little harder i
Electronics Forum | Sun Jul 26 07:52:35 EDT 2020 | sync40
Hello to everyone, Have you ever experienced soldermask bubbles inmediately after printed the soldermask itself? (for screen printing method of LPISM). I am not talking here about blistering or any outgassing defects after exposing to high temperatu
winsouce.jpg)
