Electronics Forum | Tue Oct 20 10:14:59 EDT 2015 | aemery
Florin, Not sure if this will be helpful or not, but I have completed a couple of pot height retrofits for these waves and I seemed to remember that one of my clients spilled some solder and shorted out the 24vdc power supply. I am pretty sure this
Electronics Forum | Thu Oct 22 04:45:32 EDT 2015 | myleb
Can you explain: 1. Is mc running normally before problem happens? 2. Any abnormality happens prior to problem? 3. Can you still check input/out put in machine adjustment meno? 4. Can you see all information in Ringload information? 5. If set bad be
Electronics Forum | Fri Oct 23 10:21:45 EDT 2015 | kurtiss
During production the machine Cycle Alarm ESC 3. When cycling power the error shows up again during a zero set after performing the Z1 zero set. When it errors out on zero set the only option that the machine allows is to power off. Thanks in advance
Electronics Forum | Tue Dec 29 11:38:40 EST 2015 | g2garyg2
Hi Tom If the DYNAPACE has SMEMA out all you need to do is place a two wire jumper into pins 3&4 or 1&2 depending upon DYNAPACE's SMEMA configuration. This will by-pass a Release signal and feed PCBs into the oven.
Electronics Forum | Tue Nov 17 14:48:41 EST 2015 | jpal
I have to figure out how to install a two-pin JST through-hole connector. It is a press-in style. We have pressed in larger connectors on single-sided boards with our pneumatic machine but this is a small connector on a double-sided board with small
Electronics Forum | Sun Nov 22 18:03:38 EST 2015 | ttheis
Hi Deni- Thanks for the reply. I'll try to figure out what vision system is on it. I know it has two 5.3mil cameras front and back, UPS 3.2.2c os/2. Where do I determine the type of vision system; in the computer or harware spec plate?
Electronics Forum | Fri Nov 20 23:22:52 EST 2015 | rx8pilot
Hello, I am trying to figure out if it is possible to program the index distance on Quad Tyco Feeders. I recently got a Quad IV-C and on the 16mm feeders, they index 12mm where I have an 8mm pitch tape. It is a non-IQ machine so I am looking an man
Electronics Forum | Sat Aug 19 11:09:17 EDT 2017 | sawyerh
Hi Shonen, I have gone through quite a few PCB fabrication services. I would recommend http://www.customcircuitboards.com/ They have provided me with fast deliveries (1-2 days for 2 layers) and assembly services as well. I believe they are located
Electronics Forum | Tue Dec 15 15:21:17 EST 2015 | davef
Peculiar that ENIG boards are corroded, not that it can't happen. * J-STD-002, Solderability Tests for Component Leads, Terminations, Lugs, Terminals and Wires * J-STD-003, Solderability Tests for Printed Boards The first person I'd talk with is my
Electronics Forum | Thu Dec 17 06:22:37 EST 2015 | sarason
AN inductor probably 22uH 5A. Check a TDK catalogue http://en.tdk.eu/inductors Another approach is identify the power control IC next to it and look up the App note associated with it, 9 times out of 10 it will be the same as recommended. Are you s