Electronics Forum | Fri Aug 28 13:23:49 EDT 1998 | Chrys
| | | What approach do you you use to reducing wave solder dross? What is your experience with Klennox? | | | Dave F | | Klennox should be spelled Kleenox. Dave F | Kleenox works well for removing accumulated dross as it separates the dross from t
Electronics Forum | Wed Aug 26 13:41:45 EDT 1998 | Earl Moon
| Chalk one up for the good and the bad. Who's going to play the uuuugly? | | Earl Moon | | Earl | Justin told me you were the ugly! I for one read many of the things you write and learn.............thanks | | Wayne Wayne, Always much appreciated.
Electronics Forum | Wed Aug 26 17:30:29 EDT 1998 | Clifford Peaslee
| Wayne, | Always much appreciated. Ugly, fugly, schmugly. Hell, I'm a raving beauty compared to some of you folks. I often wonder how a class picture would turn out, if at all. Also, have you heard Justin is getting married again? | Moonman Earl: I
Electronics Forum | Mon Aug 24 08:34:14 EDT 1998 | JUSTIN MEDERNACH
| Hi, | Does anyone has experiences in reflowing Ceramic BGA and found solder wicking ? Solder wicking has the syndrome that solder being wick from the pad and ended up in the leads. | We have rule out the possibility of not printing any solder paste
Electronics Forum | Mon Aug 24 11:38:09 EDT 1998 | Ryan Jennens
| | | Any competition for Teradyne on this front? Any users out there with comments? | | | Thanks in advance. | | | G | | G: Does Teradyne make flying probe testers? Dave F | Dave: | From what I hear they have introduced a flying probe tester??? H
Electronics Forum | Sat Aug 15 13:26:05 EDT 1998 | Bob Willis
| Electrical Eng. is looking for 5 micrograms per sq centimeter. After the board has been cleaned. Is this possible on a fully assembled bd? The European standard often quoted is 1.5 mg/cm which ia achievable on a board assembly please remember one
Electronics Forum | Wed Aug 12 01:35:10 EDT 1998 | P.L. Sorenson - Technical Consultant
| Hello all, welcome to the NEW home of SMTnet. We have been spending a good amount of time preparing for this switch, and we are curious about what you think. | What do you like/dislike? | Anything you'd like to see different? | Any other comments a
Electronics Forum | Mon Aug 10 10:25:54 EDT 1998 | MikeC
| Hello all, welcome to the NEW home of SMTnet. We have been spending a good amount of time preparing for this switch, and we are curious about what you think. | What do you like/dislike? | Anything you'd like to see different? | Any other comments a
Electronics Forum | Mon Aug 03 12:18:42 EDT 1998 | John Sikes
We have mixed to negative feelings about Omikron, but I beileve it is due to problems with the board fabricator rather than the process itself. When done properly, our Omikron boards have had very good solderability. However, we have had several ru
Electronics Forum | Sat Jul 25 01:25:31 EDT 1998 | Chiakl
Hi, I am currently facing alignment problem on TBGA. Before reflow, the alignment is good. After reflow, Most of the TBGA was off the pad by 25% or more. The peak temperature on TBGA is 210 C with liquidus time that about 50 sec. Paste thickness is 7