Electronics Forum | Tue Jun 07 22:01:56 EDT 2005 | KEN
run shutdown.rcp after 45 minutes computer will load shutoff.rcp. Is this file not being loaded? If yes, then you have not defined the shutoff event in the scheduler. Poke around in the scheduler. Or check out the software manual. someone probab
Electronics Forum | Thu Jun 09 07:23:03 EDT 2005 | ajaydoshi
We have BTU150 paragon. Frequent failure obseve in cooling fan capacitor. Cooling zone temperature reach up to 80 degree centigrade How to prevent same. ajay
Electronics Forum | Tue Jun 21 14:27:14 EDT 2005 | Dreamsniper
Defects will result, Your cooling rate is affected because the hot air is not circulated properly. Outgassing will appear and you'll have pin holes / blow holes, disturbed joint etc. Correct me guys if i'm wrong. Thanks
Electronics Forum | Tue Jun 21 16:03:33 EDT 2005 | jdengler
The 2 issues are: -1 Enough flow to keep all fumes from reaching people. -2 Consistent amount of heat removal to keep the temperature steady. If the 45 CFM is steady and keeps all fumes away from people all is well. Jerry
Electronics Forum | Thu Jun 23 13:15:12 EDT 2005 | jdengler
Don't forget about the exhaust. To keep the room at a positive pressure you must add more air than the exhaust from ovens and waves removes.
Electronics Forum | Fri Jun 24 04:42:12 EDT 2005 | ajaydoshi
We do have BTU 150 Paragon. What the practical air setting for all 10 zones + 2 coolig zone. This setting is to manually adjust on machine front right botton side. ajay
Electronics Forum | Tue Jun 28 00:11:44 EDT 2005 | ajaydoshi
We do have BTU 150 Paragon oven. Link fail problem occume most of the time during start of day or after Sunday. It never haven while running continiously, Any Suggestion. Ajay
Electronics Forum | Fri Sep 16 16:22:51 EDT 2005 | JW
Sounds similar to a recent problem with our VIP70. We thought it may be the SSR, then the FCU ... Swapping blower unit with a second oven finally helped us traced the problem to the thermoswitch inside the blower assembly.
Electronics Forum | Thu Jun 30 12:20:50 EDT 2005 | sumote
Its been my experience that a "dot" of glue on the center of the part is needed for "barrel" type components.
Electronics Forum | Thu Jun 30 13:49:36 EDT 2005 | John
I had the same incident before, and like GS pointed out, the degassing from the via under the component was responsible. The via was covered with solder mask, but it burst open during the reflow.
Reflow ovens for automated SMT PCB assembly, specializing in lead free processing and nitrogen reflow. The best convection reflow ovens on the market.
4 Vreeland Rd.
Florham Park, NJ USA
Phone: 973-377-6800
.gif)
