Electronics Forum | Tue Dec 23 14:45:06 EST 2008 | comatose
One thing that helps is to divide large pads into a series of smaller pads. This prevents the scooping you're talking about.
Electronics Forum | Tue Jan 20 17:12:25 EST 2009 | smt_guy
Thanks guys. They are seen on some of the pads too. What will happen if I continue to solder them and I got a good solder joint formation? Will the pad continue to erode or corode in due time? or the solder that will recoat its surface will prevent
Electronics Forum | Mon Apr 06 13:59:18 EDT 2009 | wbrenner
For your responce on OrbelE-Z SHIELD. Are you referenceing the PCB pad is 1 to 1 with the fence foot print? Thanks
Electronics Forum | Thu Apr 09 07:37:18 EDT 2009 | fowlerchang
Another suggestion for it. Baking the whole boards before rework the BGA. It is not only benifit to the BGA but also to the pad.
Electronics Forum | Wed Jun 03 13:56:09 EDT 2009 | mika
less total area of voids, which mean a much more strength in the joint and much easier to solder such a cooling pad grounded via vias, with this approach! The same goes for big cooling pads of let say Power transistors without any via etc. Always re
Electronics Forum | Tue May 19 03:19:33 EDT 2009 | cunningham
Has anyone used a hot press to bond new pads to the boards if they have been lifted? we have one and have tried and carried out some DOE's on FR4 boards but when trying the same settings on Polyamide they basically fell of can anyone give any pointe
Electronics Forum | Wed Jul 01 07:51:29 EDT 2009 | wrongway
Hello All We are going to run our frist 0402 parts soon. do I need to go to .005 stencil or will .006 work ? do I need to use a type 4 paste ? pad design does a standard rectangle work or the round pads ? Thanks in advance for any replies.
Electronics Forum | Tue Aug 25 13:30:35 EDT 2009 | rossi
It appears that the crack is between the paste and the ball. We physically pulled off the BGA by force and almost all the balls broke at the PCB. There was a thin layer of solder left on the pad. Maybe 1% of the balls stuck to the pad. I have attac
Electronics Forum | Mon Aug 24 21:43:28 EDT 2009 | davef
In reworking 0201, we: * Cut the 0201 in half with a side cutter * Heat the solder on each pad separately and flick the half 0201 off the board * Preheat a new component to +150°C with a hot plate * Solder a new 0201 on the undressed pads with a hot
Electronics Forum | Fri Aug 28 14:00:21 EDT 2009 | kennyg
O.M.G. ! Its blue pad ! ...RE: O.M.G. ! Its blue pad !... or blue balls, assuming there are BGA's on the assembly
PCB Libraries' "Footprint Expert" suite uses CAD LEAP(tm) Technology to greatly simplify footprint and 3D STEP model creation; it is used by tens of thousands of PCB designers and engineers all over the world.
Other / Media / Publisher / Online Resource / Consultant / Service Provider
24654 N. Lake Pleasant Pkwy
Peoria, AZ USA
Phone: 847-557-2300
winsouce.jpg)
