Electronics Forum | Tue Apr 11 15:37:31 EDT 2006 | stockley
(Hey Cal how you doing?) I can't resist this. You can sort of do what you're hoping for but you have to be very careful. Let the component run out and let the machine get as far as it's going to go. Then go to "Software Options", "Test commands" then
Electronics Forum | Sat Apr 15 19:11:53 EDT 2006 | daxman
If I've been clear, the parts become offset as the XY table moves around, without fiducial correction. It's when it does a fiducial correction that the placement is alright. If the placement is excellent, and I just zip the table around...load posit
Electronics Forum | Mon May 22 15:46:49 EDT 2006 | adlsmt
Grant has a good idea, we started that way also. We made a tank out of stainless steel with copper tube coils about 18" off the bottom. Circulate cold water through the tubes to condense the vapor to keep the loss down. We used electric burners under
Electronics Forum | Wed Apr 26 07:37:34 EDT 2006 | amol_kane
"Can we reuse the same machine? My point here is that the non lead free process has already coated the machine interior ( exhaust, internal flow ) with leaded component, and by conversion to lead free are we containminating the lead free product from
Electronics Forum | Wed Apr 26 07:37:52 EDT 2006 | amol_kane
"Can we reuse the same machine? My point here is that the non lead free process has already coated the machine interior ( exhaust, internal flow ) with leaded component, and by conversion to lead free are we containminating the lead free product from
Electronics Forum | Wed May 10 09:15:12 EDT 2006 | DJuelich
We currently have 5 MyData machines in our facility. Our production lines are the Mydata Synergy package which is two My9 machines connected together and both machines have the Hydra heads in them which is giving us 15k cph and these are rated at 27
Electronics Forum | Sat May 13 00:17:40 EDT 2006 | George S
I had Mydata for several years, and got a Juki 2060R about 8 months ago. If I had to choose today, it would be Juki again. The features which help me are bank changing, where I can set up offline and change over in two minutes for all feeders. The
Electronics Forum | Tue May 02 15:09:40 EDT 2006 | PWH
Just a few problems you might have to deal with: 1) Your bare boards must be clean and kept clean though-out the process. You could notice handling contamination that might otherwise have been removed in your wash. 2) You will see solder balls a
Electronics Forum | Thu May 11 12:44:04 EDT 2006 | slthomas
One of our customers' products has a couple of adjacent 0603 packages (one resistor, one cap) that are .010" apart. They are side by side, not end to end. The adjacent pads between the two parts are electrically connected so bridging isn't an issu
Electronics Forum | Sun May 21 19:14:53 EDT 2006 | grantp
Hi, I agree, and normally we would not act like this to a real person, but this guy is a joke, and it was funny to read the replies to it, and reply. Guru is never going to be part of this forum, because he's just some weird guy who's too arrogant