Electronics Forum | Mon Apr 21 16:25:10 EDT 2003 | kris
Hi, As many must be aware a number of component manufactuers maybe shipping lead-free parts without part number changes. without knowing the datecode tracked on each component it would be difficult to trace components whether they are lead-free or
Electronics Forum | Fri May 09 09:29:25 EDT 2003 | gregp
Thanks for the response k_h, A few follow up questions... 1. 70-90 slots seems low for a one machine line. What is the maximum number of different parts on your worst case job? 2. Could the common parts be adressed by being assigned as "point of use
Electronics Forum | Tue May 13 11:12:41 EDT 2003 | k_h
I currently am doing it. Keep in mind the parts are split up, such that, the chips are on one machine and the IC's and odd parts are on the second. It takes much more time to place IC's and odd parts because they need to be handled slower and often c
Electronics Forum | Tue Jun 03 22:05:18 EDT 2003 | ramanandkini
I assume you need vibratory parts feeder to improve your productivity for pin header assembly. We use lots of vibratory feeders for small, miniature mechanical parts. We also have a machine building department in our company that can handle your requ
Electronics Forum | Mon Jan 05 09:35:39 EST 2004 | ex maintain leader
Dear Sr Tech, get your spareparts in your hand and wisit SKF shop near your locations, or write out from the partlist the dimensions of the part. ! Take care wich part is it on the machine? If it is the part in the placing head (vacuum sw +/-) than
Electronics Forum | Mon Jan 19 15:33:49 EST 2004 | J Smithj
We were and still are having problems with magnetized nozzles on the HSP 4796. The problem was found when numerous parts were thrown after being placed on pad. It appeared to be picking parts up off the board after placement. Nozzles were pulled out
Electronics Forum | Mon Nov 15 07:04:05 EST 2004 | cyber_wolf
Hello all, and thanks for the responses. 1. I have changed feeders/ It's not the feeders 2. Parts are being pre-rotated 3. All other programs deleted out of machine 4. Ran parts on sticky tape/ same problem Ken : That is a very valid observation th
Electronics Forum | Thu Jun 09 15:56:19 EDT 2005 | james
I would love to buy enough feeders, just for the common parts but unless I find somewhere cheap to buy them it can very expensive. We use our own internal part numbers with using smart feeding stations. Also we are going to try to leave all the comm
Electronics Forum | Wed Sep 21 20:03:34 EDT 2005 | kevinbooth
I am going to agree with Rob a little. It is also possible that a internal ground plane might be under or connected to the pads of this cap thus causing a increase in temp to this part during reflow. This can cause parts on occasion to jump from the
Buyer, Seller, Broker of Electronic Assembly Equipment
Equipment Dealer / Broker / Auctions
309 West Pickle Alley
Rushford, MN USA
Phone: 507-864-7477