Electronics Forum | Mon Sep 21 10:52:34 EDT 2009 | smtbox
Would you please post the part number of that controller and detailed picture you are looking for? We will try our best to assist you to resolve the problems.
Electronics Forum | Mon Sep 21 03:52:17 EDT 2009 | darrenj
Found the problem. A small part had previously fallen off the nozzle, and ended up behind the left centering jaw preventing the jaw from opening up fully. Cheers Darren
Electronics Forum | Sat Sep 26 21:45:37 EDT 2009 | casmt
It didn't see the ref points on the bottom of the hydra head. start by checking the camera for dirt or dropped parts. Is it a hydra camera or Linescan?
Electronics Forum | Fri Sep 25 10:28:08 EDT 2009 | leemeyer
Are you running Q-soft software or is this an older machine running central controller ? Do you have seperate profiles set up for 0603 caps and 0603 resistors or just one profile for all 0603 parts. It sounds to me that you might be scanning to low a
Electronics Forum | Mon Sep 28 06:03:28 EDT 2009 | bobpan
You are probably scanning below the part. Adjust the scan height closer to 0 ex..(.005) and see if that works. If not....its probably the z-rod and the nozzle not seating on it correctly. Good luck
Electronics Forum | Fri Oct 16 14:45:58 EDT 2009 | cyber_wolf
Many pick and place platforms rely on nozzle spring pressure to determine how hard a part is getting pushed into the paste.
Electronics Forum | Wed Oct 21 02:42:50 EDT 2009 | jlawson
there are Maintenance - Asset management systems available but usually part of a bigger MES system, bar code driven etc, keep databases on feeders, machines, trigger times to inspect etc etc but no cheap...
Electronics Forum | Wed Nov 25 14:33:14 EST 2009 | rwyman
Our previous system was called PMC 2000 (http://www.main-tech.com/vendors/dpsi.html) We recently switched but the name of the new one escapes me at the moment. Order parts, schedule repairs and maintenance, keep a database of all the above. Good l
Electronics Forum | Tue Dec 01 01:26:30 EST 2009 | micronpt
Martin, you could buy SMT spares from us.We are an Asian precision fabrication house, specialized in the SMT machine spare/ custom made parts.Email us micronpt@micronpt.Please visit http://www.micronpt.com for more info. Thanks Siva
Electronics Forum | Thu Oct 29 08:16:41 EDT 2009 | leemeyer
A Quad IV C would fit your application well. They are work horses. Repair parts are available but they just don't seem to breakdown often.
Buyer, Seller, Broker of Electronic Assembly Equipment
Equipment Dealer / Broker / Auctions
309 West Pickle Alley
Rushford, MN USA
Phone: 507-864-7477