Electronics Forum | Fri Feb 01 12:52:31 EST 2013 | ericrr
Interesting enough, it did turn out to be alignment, maybe the machine is getting bend & twisted just like people do when they get old....... or maybe I should say as the beam gets less intense with old age the sensor needs to be readjusted to pick u
Electronics Forum | Tue Jan 29 09:59:24 EST 2013 | jgarver1
We do sell the cables that will connect your conveyor to the Fuji CP 42. Contact Larry in our parts department. 281-259-9660
Electronics Forum | Sun Feb 10 15:14:25 EST 2013 | marcelorotofrance
After an in depth examination, I found that the problem was not a defective connector as I thought in the first place. Actually is a broken through-hole on the Quad Align sensor. I requested a spare part to PPM. Mr. Bobpan, thank you again.
Electronics Forum | Tue Oct 22 19:59:21 EDT 2013 | larrygroves
move the aligner. they are pinned and will likely work without calibration. Yes I sell parts and service. give me a call I have an e copy of the service manual
Electronics Forum | Fri Feb 08 15:50:49 EST 2013 | emeto
We usually run QFNs with 2N placement force. However for some parts we will modify the placement to higher value to make sure they stick to the paste good.
Electronics Forum | Mon Feb 11 11:45:30 EST 2013 | bobpan
I dont know where you got your feeders at. I have worked on alot of quad feeders and i have never had one that wasnt repeatable enough for 0805 or 1206 parts.
Electronics Forum | Thu Feb 21 08:52:24 EST 2013 | emeto
Currently having Elecrtovert and BTU - no problems with both. Before use to have Vitronics aand Heller - and no problems with the rails. However I had other problems with Heller which makes me think that they are going deeper with the bad quality par
Electronics Forum | Thu Feb 28 10:40:56 EST 2013 | rway
I have been doing this since day one of getting the AOI. It just seemed logical. I don't know what type of AOI you have, but what I have found works best is to use solder inspection to catch parts that are loaded into a no-load location. Move the
Electronics Forum | Mon Mar 04 17:15:34 EST 2013 | ppminc
I apologize about this. We have sent you over a quote today, we do have all of the parts in-stock and can repair your Quad Align. Please call 9AM-5PM EST or email us anytime.
Electronics Forum | Thu Mar 07 03:32:32 EST 2013 | benreben
Hi, Can you move the X2 axis manually? if you move head manually(twice) can you see the pulse incremented in the servo menu in IP? with servo just have some parts can defects: -servo it self -servo board -encoder on head
Buyer, Seller, Broker of Electronic Assembly Equipment
Equipment Dealer / Broker / Auctions
309 West Pickle Alley
Rushford, MN USA
Phone: 507-864-7477