Electronics Forum | Fri Jul 08 09:14:49 EDT 2005 | Jason Fullerton
I've tested boards with SN100C HAL finish, and wetting to the PCB finish was poor at best, using a no clean SAC305 paste.
Electronics Forum | Tue Jul 05 05:23:34 EDT 2005 | kentes
We have one set MPM AP25. Its prestop position is not stable,but stop position is stable. It often occur "time out" alarm when load PCB.Which one can help us.
Electronics Forum | Wed Jul 06 10:22:04 EDT 2005 | PWH
At times we have had this problem with our AP25 due to one of the conveyor belts slipping. Load a PCB and check to see that both conveyor belts are running at the same speed. If not, tighten the one that is dragging. Hope this helps.
Electronics Forum | Wed Jul 06 04:38:43 EDT 2005 | javi
AJ, Thanks for your input, forgot to inform that there is none BGA on the PCB. I also discovered that there was another topic related mixed component that give me support enough. Will inform my supplier to perform the process in the SMT line and not
Electronics Forum | Mon Jul 11 11:00:05 EDT 2005 | mmjm_1099
Alcohol and a scrub brush or try some 440R (http://www.smartsonic.com/). This stuff cleans almost anything off.
Electronics Forum | Thu Jul 14 16:08:07 EDT 2005 | russ
Stencil thickness is related to PCB design and is not related to paste type. If you release with a 8 mil stencil then use an 8 mil stencil. Of course there are pastes that release bteer than other and what not but use area and aspect ratios to dete
Electronics Forum | Tue Jul 19 12:07:03 EDT 2005 | CLampron
Sr tech, It is in the PCB header information. F2 from the layout editor then F1 to view through the camera. Regards Chris
Electronics Forum | Wed Aug 03 14:17:28 EDT 2005 | GS
What about PCB construction?: - CEM (2-3....)? FR4 ?....? - how many layers - what about TG ? GS
Electronics Forum | Wed Aug 03 08:42:02 EDT 2005 | ianlg
Hi Here is one that can handle the size board that you are looking to print. http://www.reprintservices.co.uk/R29_Series_Screen_Printer.html Hope that this is of help. Regards Ian
Electronics Forum | Wed Aug 03 10:03:25 EDT 2005 | Rob
There's always a used MPM UP3000, they're cheap.... ....but there is a very good reason for this.
Golden State is a contract manufacturer that makes wire harnesses, electromechanical assemblies (box builds, subassemblies, PCBAs, kits, etc.) and services (sorting, rework, value additive manufacturing engineering)
18220 Butterfield Blvd
Morgan Hill, CA USA
Phone: 5102268155
