Electronics Forum | Wed Nov 16 17:18:42 EST 2022 | emeto
Volumes are not the only factor here. You might have low mix and low volume, but high complexity. Machine you pick based on the most challenging components you have to print/place/reflow. If boards are simple, than your level of expertise is importan
Electronics Forum | Fri Nov 25 11:55:22 EST 2022 | poly
So I'm attempting to run feeder teach for my platform tray feeder... but I've got no idea what first point I should teach is... normal is the end pin of the feeder but this is for the ptf conveyor... so I've got no idea. If I just teach each corner
Electronics Forum | Thu Dec 01 14:48:48 EST 2022 | peterm
Hi, The detailed instructions should be in Voyager under PTF Installation. It's basically a kit where you pick up a metal plate and you teach that component on the belt directly. If you don't have access to the kit I'd just start of with the default
Electronics Forum | Sat Dec 10 08:26:14 EST 2022 | poly
That procedure all works perfectly, and I'm read through that section of the manual however... 12. Perform Feeder Teach. Refer to the Feeder Teach Voyager help topic. I can't find anything in Voyager that explains the feeder teach procedure for t
Electronics Forum | Mon Dec 12 09:41:57 EST 2022 | poly
Thanks Peter, when I open feeder teach i'm presented with a bunch of actions. I can't find docs on what the different actions are. Do you know which one I should do? I have attempted to teach the corners but the value it gives put the PTF pick point
Electronics Forum | Thu May 04 13:16:07 EDT 2023 | tommy_magyar
If I would need to investigate this claim, I would ask the following questions: - was traceability used when this product was manufactured? - was testing mandatory when this specific product was built? - is the test covering the QFP we are talking ab
Electronics Forum | Mon May 15 18:31:28 EDT 2023 | daniel_stanphill
I have found Superior No. 75 to be an absolute miracle worker when it comes to nozzle maintenance. I let our worst nozzles soak in that over the weekend and then the majority of the dross would literally flake off with light pressure from a pick/scre
Electronics Forum | Mon Jul 31 07:37:57 EDT 2023 | tommy_magyar
Hi Simon, Yes, red glue should help, assuming that it is being dispensed by a glue dispenser. For stencil printing I used yellow glue in the past (can't remember the brand). Your pick and place machine should be able to achieve on it's own 35 um
Electronics Forum | Fri Sep 15 09:26:14 EDT 2023 | georgegr777
Hello everyone, my problem is that my cp40cv pick&place machine is not loading the the machine software and on VME162PA242 card the "fuses" led indicator is blinking. Instead on my second cp40cv machine that works ok the fuses led i
Electronics Forum | Tue Jan 30 14:18:22 EST 2024 | spoiltforchoice
It might be worth mentioning that Speedprint (now Europlacer) printers also have a calibrate using your own board capability. They arguably also target higher mix environments given that is the market the pick and place machine targets. DEK uses a v
winsouce.jpg)
.gif)