Electronics Forum | Sun Feb 13 18:47:21 EST 2011 | gabriel1blue
Thank you for your fast reply, head 1 moves to the pick up location and stays up, then it moves to the dump location and moves down to drop the part, it was running before just the offsets where off (moving up and down). If I chance the head from hea
Electronics Forum | Wed May 04 21:32:30 EDT 2011 | jimlas53
Thanks for the answer, RLM, I couldn't find anything in the manual that was helpful. If I use a common extent for each component type, I need to identify those components that may be turned due to the feed type (tape, vibe). Is this where I would d
Electronics Forum | Thu May 05 11:11:20 EDT 2011 | jimlas53
OK, understood. In the case of SO14, I have some in vibe feeders and some in tape. The tape parts, when I set the extent up, would be picked at 0 Theta, because the part length is parallel to the Y axis. The vibe parts, which are perpendicular to
Electronics Forum | Tue Jun 07 00:21:42 EDT 2011 | jacki
Hi All Currently, we encountered that the schottky barrier diode was up side down or misalignment during SMT process.And, many parts were blown away as pick up error. What we found is its package space is a little bigger for parts to move. I seek y
Electronics Forum | Mon Mar 05 23:10:25 EST 2012 | vinitverma
The algorithm only checks if all the 8 parts can be picked up by 8 heads without any mechanical interference during pickup or during rotation. In case if foresees any interference it divides them into two different charges instead of one. You can try
Electronics Forum | Wed Apr 04 09:20:20 EDT 2012 | acsscott
I have continued to try and make this work, but I've had no success. I have tried everything that everyone has suggested. It might be the component height, but I can't change that. I guess I could increase the resistor thinkness, and add some heig
Electronics Forum | Thu Mar 22 04:03:04 EDT 2012 | vinitverma
The difference between FCM I and FCM II is not only the use of pusher. The vacuum calibration pads are also in different locations - in front in case of FCM I and in the rear for FCM II. Also the pick positions (coordinates) as well as location numbe
Electronics Forum | Sat May 12 01:46:19 EDT 2012 | miulius13
Hello guys, I hope this thread is located properly! I have few designs made in OrCAD Layout and I need to switch them to automatic assembly but I've been told that I need pick and place files for them ... hence my request for you: How can I export t
Electronics Forum | Wed May 23 18:45:57 EDT 2012 | stentech
I would agree with Sr Tech..Grid lock and systems like this can be used on the Ekra, MPM and DEK printers also can be used in Pick and place depending on the density of pin. If you choose the method of printing out a 1:1 photoplot. Glue it to a piece
Electronics Forum | Sat Sep 29 19:04:13 EDT 2012 | e_music
Hello, I have just installed the demo version of GC-Powerplace. Could anyone here walk me through the process to generate pick and place file from gerbers? I don't have solderpaste layer. All I have got is signal layers (top/bottom), soldermask, sil
.gif)
