Electronics Forum: pickups (Page 1 of 40)

Waffle trays

Electronics Forum | Wed Mar 07 09:29:36 EST 2001 | gsmguru

Enter A value of -1 in the Tray pickup X & Tray pickup Y fields. This will disable the automatic empty tray pickup by the machine. I would recommend getting a data sheet on the tray from the component vendor for accurate pocket & tray dimensions. Var

Quad 2c - QA Error #0?

Electronics Forum | Fri Nov 26 10:28:09 EST 2010 | cruoff

QA Error #0 The strange part is that if I reprogram the Pickup over and over again, using the same variables, eventually the error goes away and does not return for that particular pickup. However it will occur again for subsequent pickups. Has

ODD FUJI IP3 PROBLEM

Electronics Forum | Wed Oct 17 08:09:09 EDT 2012 | fujiphil

This problem is caused by poor pick-up. Check the pick-up from MTU to shuttle, then shuttle to placing head 1. If the pick-up is not centered, adjust proper data.

Universal GSM dumping trays with parts still in!!

Electronics Forum | Thu Mar 08 16:00:03 EST 2001 | gsmguru

Enter A value of -1 in the Tray pickup X & Tray pickup Y fields. This will disable the automatic empty tray pickup by the machine. I would recommend getting a data sheet on the tray from the component vendor for accurate pocket & tray dimensions. Var

ASSEMBLEON AX-5

Electronics Forum | Tue Oct 28 13:00:56 EDT 2008 | exman

ax-5 having problem with pickup problem when the head placement try to pickup the component on the feeder the toolbit will fall off eventdo teach the part center very good but when they pickup it off about one inch happent on ly robot #1 the rest of

Reject Rate

Electronics Forum | Mon Nov 16 01:35:15 EST 2009 | chandika

for reject rate depends on various parameters, Part data parameters, (Body tolerance,Part pickup & transport speed etc. ) Also depend on vaccum level, ( During the PM we need to messure pickup nozzle vaccumlevel using manometer ) According to raw mat

Quad IV-c feeder error

Electronics Forum | Fri Feb 01 07:21:32 EST 2019 | dfl

One of my 8mm feeders is blinking the red led after the pick-up. With both buttons the motor works as expected (forward/backward), but after the nozzle pick-up the motor moves forward and then the red led blinks. pressing the buttons the green led l

Samsung cp40 pickup tolerance

Electronics Forum | Tue Apr 16 01:42:15 EDT 2019 | ledze91

Hello. Got problems with big elements like connectors. Pickup tolerance dont work on cp40/Lv. Here got two machines cp40/lv and one cp40/cv. On cv dont have problems with pickup, but on Lv nozzle hit the pins of connectors or wont pick up

Does Fuji have adaptive pick?

Electronics Forum | Wed Dec 23 21:27:26 EST 1998 | Jim Mitchell

Many machines now have adaptive pick that helps tune in the pickup as the 0402 part moves around in the pocket. Fuji may have a feature like this, but I think they adapt the pickup in only one axis (by adjusting the feeder rack). Unfortunately this

QUAD IVC Pickup Problem on Z Axis

Electronics Forum | Sun Jun 07 11:47:10 EDT 2020 | saduquette

Hi, I went to run my IVC yesterday and it got a Motor Error on first pickup. Pressing Enter showed Z:-27:0 So according to the manual that means the Zaxis was commanded to go to -27, but the limit is '0'. I tried a Function 3 on that pickup and

  1 2 3 4 5 6 7 8 9 10 Next

pickups searches for Companies, Equipment, Machines, Suppliers & Information