Electronics Forum | Fri May 24 11:49:55 EDT 2002 | stefwitt
Again, I would like to refer to the tape dimensions and their deviations. In an 8 mm tape the distance from the sprocket holes to the tape pocket is 3.5 mm +/- 0.05 mm. This tolerance is easy to achieve, because in the manufacturing process of the ta
Electronics Forum | Thu Aug 28 16:13:06 EDT 2003 | Dan Gosselin
Thanks everyone for your help. I have since found a good article I am downloading of of the SMTA website. Dan Title : EFFECT OF SURFACE TENSION OF SOLDER ON UNDERSIDE DEVICE SUPPORT DURING REFLOW OF A PCBA Author : Mulugeta Abtew Author Company
Electronics Forum | Mon Oct 13 13:34:13 EDT 2003 | caldon
HI Andrea- to answer Q: 1) Stencils can be order through various vendors that manufacture stencils. You would need to have CAD data for the Stencil company to make them. You design engineer should have the CAD info. Also, the stencil design company c
Electronics Forum | Mon Dec 08 18:52:47 EST 2003 | Craig M
Stability of process is what your measuring so lets not assume a stable process(if your process was perfect you would have no defects). With no test a medium complexity board will be around 68.7% (according to Consulogic). I dont have many other sour
Electronics Forum | Mon Apr 26 15:04:14 EDT 2004 | pjc
You are correct in understanding that the vision system comes into play for subsequent boards- to align them. Yes- if you missalign the first board and set the cameras to that board, all subsequet boards will not be aligned. Mylar is a thin polyester
Electronics Forum | Mon Jul 26 21:56:53 EDT 2004 | pdeuel
The camera is not driven from the motor cards. The camera is attached to what is called a forcer. For the Y axis there are two of them. One is wired backwards from the other. one of the forcers is connected to a flex chanell for the air and electrica
Electronics Forum | Thu Jul 22 04:28:05 EDT 2004 | ouch
Hi, I'm new here, but I have a problem that I don't see discussed. I am trying to repair a Zilog Z80 Encore Board. these boards use 4 layers. you can see the board here on page 11: http://www.zilog.com/docs/z8encore/devtools/um0151.pdf I have bough
Electronics Forum | Fri Apr 22 14:28:38 EDT 2005 | Gary Goldberg - PROMATION
Low end selective laser soldering systems are limited to what types of soldering can be performed. I have read through the previous comments and find that most have commented on earlier technologies (which do not offer the features today's system do)
Electronics Forum | Wed May 18 14:58:05 EDT 2005 | splice
Hi, I am having some PTH non wetting issues. Setup and chronology of events is explained: Set Up; Part: 1 MM pitch connector 378 pins Solder: Kester Ultra Pure 63/37 solder Pot; 250 C pre heat; Peak 94C top side Flux: Qualitek 775, Fluxer: foam T
Electronics Forum | Sat Dec 17 08:07:06 EST 2005 | grantp
Hi, What worries me is that a lot of people speak about what they have heard, but there is no firm facts on exactly what the situation is. I did a seminar on lead free a while ago, and was told that going lead free on the components while running l