Electronics Forum | Wed Apr 06 11:10:47 EDT 2005 | smt_rookie
We process a double-side reflow board (10 ups). Chips and IC's on the bottom side while chips, IC's plus thru-hole connectors and IC sockets on top side (bottom side first then top side reflow). In the past, we were not encountering any soldering pro
Electronics Forum | Wed Apr 06 11:54:24 EDT 2005 | Indy
did you try using double header connector pin of a different lot? Indy
Electronics Forum | Sun May 08 07:09:04 EDT 2005 | Rick Iodice
We are continuing to struggle with voids under BGA's. Our problem are not consistent. some CCA's are perfect but others have pin hole sized voids. Does anyone have any feedback on Indium 92j and how it performs for bga's?
Electronics Forum | Fri Jun 03 03:27:36 EDT 2005 | Rob
http://www.keyelco.com/pdfs/prod03-coinholders.pdf Bottom of page 2 of 3. There is a reasonably large heatsink function on one of the pins due to the size of the Anode/battery spring clip.
Electronics Forum | Thu Jun 16 14:18:26 EDT 2005 | Confused
I have a 100 pin TQFP with a logo the same as mitsubishi 3 diamonds. does anyone know this logo it's not mitsubishi because I can find no sight for them only cars. Anyone know this logo?
Electronics Forum | Tue Jun 21 14:27:14 EDT 2005 | Dreamsniper
Defects will result, Your cooling rate is affected because the hot air is not circulated properly. Outgassing will appear and you'll have pin holes / blow holes, disturbed joint etc. Correct me guys if i'm wrong. Thanks
Electronics Forum | Thu Jun 30 05:08:41 EDT 2005 | saddo
wanna know part no. ! Marking on top-side "GVH", 6 pins very small IC. I guess it is a kind of switch for Tx/Rx. Anybody seen "GVH" ?
Electronics Forum | Wed Jul 20 17:23:19 EDT 2005 | davef
IPC-2222 - Sectional Design Standard For Printed Board For Organic Printed Boards, Table 9-3 � Plated Through Hole Diameter To Lead Diameter Relationships will give you the standard information you require.
Electronics Forum | Tue Aug 09 13:44:48 EDT 2005 | mtd
The solder on the rest of the board looks good. There are no large components around these parts. We check the profile using a KIC and it met the recommendations of the solder paste manufacturer. I have not did a dip test of the board or components.
Electronics Forum | Wed Aug 31 11:40:24 EDT 2005 | stepheniii
I just had a "how could I have forgotten" moment. By any chance are these double sided boards and the cracked components are on the fist side? If so support pin placement could be the problem. In case more info would be good.