Electronics Forum | Sun Apr 25 04:34:09 EDT 1999 | Earl Moon
No this message isn't about my triumphant return. It's not even about that lady I wanted to run away with to Mehico (who were you again). It's about progress and some of you might be interested, or not. 1) For DEKheads, I submit we had two of Britai
Electronics Forum | Sun Apr 18 00:47:11 EDT 1999 | Steve Gregory
Yeah Earl, I hear ya... I registered, but did so rather grudgingly. Ya'll must've noticed that I haven't been here much lately. I really haven't thought much about why, but maybe it's been a subconscious thing...like it's too much work to go here an
Electronics Forum | Wed Sep 02 08:52:13 EDT 1998 | Justin Medernach
| | We are experiencing shorting on a BGA. The part has a 1mm pitch with a 196 I/O count. The problem seems to pop up without warning & disappear in the same manner. | | Our pad design is .020" diameter pads with .025" solder resist diameter. Th
Electronics Forum | Tue Sep 01 10:39:30 EDT 1998 | Mike
| | | We are experiencing shorting on a BGA. The part has a 1mm pitch with a 196 I/O count. The problem seems to pop up without warning & disappear in the same manner. | | | Our pad design is .020" diameter pads with .025" solder resist diameter.
Electronics Forum | Wed Jun 03 21:25:33 EDT 1998 | John Allan
| Hello: | BACKGROUD: SMT components soldered on the top-side of boards that also require wave soldering have the potential to reflow during wave soldering. Reflowing these components during wave soldering is not good. It can cause cold joints, op
Electronics Forum | Thu Jun 04 08:32:21 EDT 1998 | Dave F
| | Hello: | | BACKGROUD: SMT components soldered on the top-side of boards that also require wave soldering have the potential to reflow during wave soldering. Reflowing these components during wave soldering is not good. It can cause cold joints
Electronics Forum | Thu Mar 05 13:17:19 EST 1998 | Justin Medernach
| Hello everyone! | Does any know anything about bare board size variations? | Is there a spec. or tolerance? | I'm running small lots of boards and during the screen printing process | I find that I cannot paste each board perfectly.I've tried other
Electronics Forum | Thu Mar 05 23:52:26 EST 1998 | Ron Costa
| Hi Ron, | Your question really opens up a "Pandora's box", but when you say you're not able to print perfectly, what is it exactly that you mean? Is the print lacking volume? Is it mis-registered? Are you bridging? Also, what printers have you used
Electronics Forum | Thu Sep 19 11:14:45 EDT 2002 | Jim M.
We had lots of problems with bridging on 15.8mm pitch, QFP17-160 at the start.The board was .032 thick, double sided-six boards to a panel. Here is the problems (not neccessarily in the biggest to little but as i remember them) and solutions that he
Electronics Forum | Thu Sep 04 10:24:39 EDT 2003 | paulrm
The typical PIP process is incorporated into the surface mount process. This approach requires the following: The stencil will be designed so that the correct amount of solder paste can be printed onto the through-holes to form an acceptable joint