509 plugging results

Electronics Forum: plugging (Page 31 of 51)

Re: DI Filration And Bacteria

Electronics Forum | Fri Apr 24 23:03:28 EDT 1998 | Mikec

BGA Via Plugging

Electronics Forum | Thu Feb 07 20:53:51 EST 2002 | davef

Regardless of the technique used for the mounting pad shape or definition, isolation of the plated through hole [PTH] from the mounting pad is important. If the PTH is contained within the mounting pad, solder will wick down the PTH. The amount of

240v A/C playstation to run from 12v D/C battery

Electronics Forum | Thu Sep 26 15:34:46 EDT 2002 | mustard

i Know its possible cus i read that it has been done by several people but i am after finding out how to do it for myself. I want to wire up a playstation to (hopefully) a DC jack so when i need 240V A/c to use it i can simply plug it in and likewis

MPM Hi e

Electronics Forum | Wed Aug 02 15:19:29 EDT 2006 | SWAG

Sounds like air pressure is set O.K. The next thing to check is that the platen surface that the x and y axis ride on is perfectly clean. After that, you should knock the camera off the platen and make sure that all of the small air nozzles are blo

how to prenvent flux risidue in the blind vias.

Electronics Forum | Mon Feb 19 22:56:20 EST 2007 | davef

Russ We agree with your comments on plugging from one side only. But... We believe that it IS possible to trap process chemicals [technically, not flux] in a blind [or any other] via. This can be done by plating the via closed, rather than pluggi

Mydata A12 tool tip damage

Electronics Forum | Fri Jul 20 07:09:29 EDT 2007 | chrispy1963

Sr. Tech, youre absolutely correct that the X-Wagon (pancake) motor is the one which will do final positioning when moving to a programmed position. The X Axis motor in back of the machine is used for rapid traverse of the axis. I was thinking more

Omniflo 10 power failure detected

Electronics Forum | Mon Apr 29 00:29:11 EDT 2013 | aemery

If you have a UPS on your machine there should be auxiliary contacts in the main breaker switch SW 1. These contacts tell the UPS if the main rotatary switch in turned to on or off. If the rotary switch was set to off the UPS knows not to turn on i

MPM AP/A Screnn Printer - Dispense Pinch Disable

Electronics Forum | Mon Sep 02 15:41:47 EDT 2013 | aemery

Mr Duckmann2000. Where is the leak??? Is it up on the dispenser behind the printhead? If so the simpliest thing to do, assuming you are not using the dispenser, is to cut the incoiming air tubing to the dispense pinch, fold it over and ty-wrap it.