Electronics Forum | Fri Jul 02 09:54:02 EDT 1999 | John Thorup
| | | | We are wave soldering some fabs with a lot of unmasked trace area along the edges. The trace area is solid copper covered with tin / lead, no masking, no components along the edges, same on solder side and component side (goofy board design)
Electronics Forum | Fri Jul 02 10:06:17 EDT 1999 | John Thorup
| | | | We are wave soldering some fabs with a lot of unmasked trace area along the edges. The trace area is solid copper covered with tin / lead, no masking, no components along the edges, same on solder side and component side (goofy board design)
Electronics Forum | Fri Jun 25 01:11:31 EDT 1999 | Vinesh Gandhi
| | | Recently, there has been an upsurge in the Pin Hole/Blow Hole problem in our wave soldering process. We are baking the PCBs for 2 Hrs. at 125 degree C. The Wave Soldering profile seems to be O.K. Still the problem is persistent. Can somebody
Electronics Forum | Thu Jun 10 12:10:41 EDT 1999 | Earl Moon
| | | I am starting a new project which involve 3 oz copper layer with 20 mil components on the top of the board and 0.040" thick copper with D2Pak on the bottom of the board. | | | There is anybody has experience on metal-based PCB reflow process?
Electronics Forum | Tue Jun 08 15:04:06 EDT 1999 | JohnW
| | | Hi,my master | | | How to iron out such soldering bridge with below conditions: | | | 1.The component(Harness)lead pitch is 2.0mm,the lead length is 3.2mm. | | | 2.PCB width is 1.6mm.Pad size is 1.65mm.Its a single copper PCB | | | 3.using s
Electronics Forum | Sun May 23 07:13:56 EDT 1999 | Scott Cook
| Has anyone had any experience or data using vibration during the reflow process. | We introduced a vibration device attached to the fixed rail on a Vitronics reflow oven. The reason was to prevent skewing on large PLCC devices. The process worked v
Electronics Forum | Wed May 19 10:48:40 EDT 1999 | Glenn Robertson
| | | We are currently looking at purchasing some BGA rework equipment. Could someone give us the pro's and cons of IR heating (top/bottom)vs. hot air convection ? | | | All other tips are also welcome. | | | | | | Thanks | | | | | Philip, | | I ha
Electronics Forum | Sun Apr 25 11:50:08 EDT 1999 | Earl Moon
| | | We are just starting to manufacture a PCB with a .039" fine-line PBGA. We are currently seeing voids, mainly in the center, that are as much as 45%. We also intermittently see the corner balls of the PBGA smaller than the center balls. We are u
Electronics Forum | Mon Mar 08 23:43:54 EST 1999 | Dean
> Alignment issues are not so critical on most any system, but thermal >>(top and bottom heater settings) certainly are. Without a serious >>system, I just don't see how it can be done. | | | | Thanks again Earl for your valuable communications..
Electronics Forum | Thu Jan 14 15:10:14 EST 1999 | Earl Moon
| | Hi Folks. Has any Process Engineer here done a complete evaluation or controlled experiment for VOC-FREE Flux? Our goal here at CEBUKid, Inc. is to implement a VOC-FREE process. We have all the necessary (OPTIFLUX) spray equipment, and we're c