Electronics Forum | Tue Oct 14 10:52:35 EDT 2014 | swag
Can't help you with the manual but do have some tips: If it was shipped, it's possible someone tied axis or blocked stuff for shipping. Look for that. Look for bent sensor flags + go into I/O and check to see all sensors you can find are working.
Electronics Forum | Sat Oct 18 22:41:54 EDT 2014 | pfifla1
Can't help you with the manual but do have some > tips: If it was shipped, it's possible someone > tied axis or blocked stuff for shipping. Look > for that. Look for bent sensor flags + go into > I/O and check to see all sensors you can find a
Electronics Forum | Tue Oct 28 17:15:46 EDT 2014 | grayboard
Hello, I am looking into the use of a Samtec SEAM-50-02.0-L-10-2-A-GP-K-TR on a board. Is anyone around who has experience with this component? Specifically, we are looking for design advice for stenciling and soldering. The component is a sold
Electronics Forum | Tue Dec 16 22:09:36 EST 2014 | deanm
The critical operations where cross contamination can occur is the paste printer, the touch up station and the hand soldering station. Hand insertion should not be a problem if the parts are kitted or issued with proper control. If possible I would
Electronics Forum | Thu Dec 18 13:07:50 EST 2014 | kevinb
I have worked with Epoxy Technology in the past with silver epoxy. Just to fill you in on what I have been doing with this project in the past. I was using a silver epoxy for my 0201s. I then over molded with an epoxy with a dam and fill. Then th
Electronics Forum | Sun Feb 22 15:46:09 EST 2015 | slave2anubis
Hi, my name is Dacian, and i run a mobile phone repair shop in Timisoara, Romania. Lately we decided to do more advance motherboard repair jobs, and a big problem that we have is, cleaning the board after we remove the chips. We repair manly iPhone,
Electronics Forum | Thu Aug 27 05:49:53 EDT 2015 | alexeis
Hi, To calculate both values you need: 1. Theoretical speed of all machines (Printer, SMT, Reflow). This is a basic upper limit value of speed. Use it for calculate a maximal theoretical values as upper limit. For real values, read next. 2. High r
Electronics Forum | Thu Aug 27 11:18:05 EDT 2015 | dyoungquist
From your description I am assuming you are doing double sided reflow and parts are dropping off the bottom side when the board is run through the reflow oven the second time. A few ideas to try: 1) Are the parts that are dropping off heavier parts
Electronics Forum | Wed Sep 16 18:06:14 EDT 2015 | pmcg
Problem with cleaning these machines is once you start it's easy to get carried away. ;) We cleaned our SPA-400F a few months ago, had been offline for a while as we were using our SPA-250. It started as just a clean and to replace all the flux pip
Electronics Forum | Mon Oct 12 03:09:06 EDT 2015 | akon63
Problem with cleaning these machines is once you > start it's easy to get carried away. ;) > > We > cleaned our SPA-400F a few months ago, had been > offline for a while as we were using our > SPA-250. > > It started as just a clean and to > r