Electronics Forum | Tue Jul 17 10:25:59 EDT 2007 | hussman
You want to know which flux will over come thermal mass problems? That's easy - none.
Electronics Forum | Sat Aug 18 12:28:46 EDT 2007 | shing
I have checked all the method before, the problem still exists. Is there are more easy way for operator to visually check solder paste on golden finger? for example: using a special light as a tools for operator to identify the problems easily.
Electronics Forum | Wed Aug 15 14:46:14 EDT 2007 | babe7362000
Has anyone else out there had problems with this machine? I just wanted to see others opinions on this machine. Thanks for any input.
Electronics Forum | Mon Sep 03 06:17:19 EDT 2007 | mun4o
hi, This is moisture problem, I think.I have similar problem.You must try to bake PCBs.I bake our PCBs in solder wave mashine , under solder pot.There T is about 80*C - after 6-8h the PCB is dry regards
Electronics Forum | Fri Aug 31 00:08:10 EDT 2007 | ventron
Hi all, Please help me to solve this problem: When I turn on MCS30, it couldn't boot. It appears this error: " BOOT DEVICE ALL FAIL !". Please help me ASAP. Thanks,
Electronics Forum | Mon Sep 10 10:21:42 EDT 2007 | mgrimes
Having a problem with a MPM AP/A. Once a board is programmed; all is calibrated and the first board screened - each board thereafter drifts and gets progressively worse. The drift can range from barely off to half off the pad. Any ideas?
Electronics Forum | Mon Sep 10 10:42:49 EDT 2007 | chrisgriffin
Set "FP" mode to 1 in the setup menu 1. It won't fix your problem, but it might help a little. What kind of board support system are you using?
Electronics Forum | Thu Nov 01 21:05:31 EDT 2007 | davef
no inspection * Failing to meet expectations => inspection In asking if you observed the problem at incoming inspection, we should have asked the question differently. Have you observed the problem in stock items, prior to assembly?
Electronics Forum | Wed Mar 26 16:10:13 EDT 2008 | kpm135
When was the last time your ELA was calibrated? I had an operator ding the camera some how and the machine acted very much as you describe afterwards. A camera calibration corrected the problem.
Electronics Forum | Fri Apr 04 14:49:51 EDT 2008 | tombstone
Flux seperation is a common problem observed due to expiration of paste. The symptom is a yellow layer of flux when you open the jar. Excess flux separation will cause priting problems such as smearing and slumping.
