Electronics Forum | Mon Oct 24 13:17:18 EDT 2022 | micropak
I have successfully used "Offset" in pick position on a particular feeder/component on F3. My L/C is Linux 503.04 and SC software is probably 010 (RMOS). This 406, you are mentioning as Station software ? I believe you have to do it in feeder setup,
Electronics Forum | Fri May 05 21:10:41 EDT 2023 | zsoden
Hi ELC, I'm curious about your comment of calibrating the Z axis. Our UP2000 has been moved around a few times and we've never done this nor noticed a need to. Could you please share some more information and even perhaps the calibration procedure?
Electronics Forum | Fri Apr 05 01:52:57 EDT 2024 | ddfreeze
Samsung SM321 machine fails to initialize when booting software. I have swapped PCI and communication boards, all resulting the same, I replaced the CMOS battery on communications board, tested the voltage on the backplane, and reloaded the software
Electronics Forum | Wed Mar 29 09:31:28 EST 2000 | Erick
Marc: My experience found reliability IS a function of operator skill and attension to the process. Expecially for some RF assemblies. I worked with an engineer from Rogers to develope a process for reworking Pads for a special material. (I thing
Electronics Forum | Fri Oct 01 23:43:28 EDT 1999 | Jeff Ferry
| | Can someone help me find info on gold repair? I know it can be done, but I need to know how expensive it is, etc. | | | Paul: The following seel gold finger repair kits, in-case you haven't had your dose of heavy metals: | | Hunter Products 79
Electronics Forum | Tue Apr 20 14:25:05 EDT 1999 | Stephen Smith
I am wondering if anyone has any info regarding solder paste misprint clean-up procedures for Entek Plus CU-106A PCB's utilizing a water-clean solder paste. In a implementation procedure they recommend a 2-3 minute wash cycle with the following crit
Electronics Forum | Sat Mar 24 12:31:31 EDT 2007 | diesel_1t
Hi there. Ok, i have a little big question for fuji Erudites: when machine run out of parts on any device it tells to machine "parts out (and part number)" So, a signal from anywhere (maybe a PLC output) will tell to the machine "hey i'm out of parts
Electronics Forum | Mon Dec 05 09:14:14 EST 2022 | peterm
Invoke. The PTF Setup Procedure dialog box displays. 4. Select Product. The Select Product File dialog box displays. 5. Select the same product used in the Open PTF Teach Product section above. 6. Enter the Slot number for the PTF and select Full
Electronics Forum | Wed Apr 04 20:22:35 EDT 2007 | diesel_1t
Totally agree on what you said, but there's some other things involved: There's not enough training, here in Juarez, Mexico, the level of pesonal turnover is very high so when you train on certain procedure, they leave for some reason and always is
Electronics Forum | Thu Aug 22 01:57:30 EDT 2002 | Bob Willis
Although the following is not true capability machine assesment I feel that monioring the process at screen print, placement, reflow and wave gives results for both design and process guys to asses thire process. The project has been running since Ma
