Electronics Forum | Mon Jun 21 12:02:36 EDT 2010 | roland_grenier
check your de-panelling process if you are using break-out tabs or V scoring.
Electronics Forum | Fri Jul 16 15:20:12 EDT 2010 | davef
Duno. I'll shoot Daan an email.
Electronics Forum | Wed Sep 15 01:16:36 EDT 2010 | dan_ems
Hello, what type of solder paste use, and this component is made for lead process?
Electronics Forum | Wed Sep 15 03:04:13 EDT 2010 | genesan
kester 562 clean process and this leaded part.
Electronics Forum | Wed Sep 29 14:24:34 EDT 2010 | mazjal7
SWAG, Thank you for your suggestion, you brought a very good point.
Electronics Forum | Sun Oct 31 10:58:52 EDT 2010 | cobar
http://www.shanelo.co.za/Design,%20process%20and%20reliability.htm
Electronics Forum | Fri Dec 17 10:42:58 EST 2010 | hegemon
I believe there is a lot pertinent information in the thread that Dave forwarded... But (IMHO)I think you can look at two things first. First, is your wave solder process friendly to this large PCB, is there enough pre-heat in the board before it h
Electronics Forum | Thu Dec 16 11:25:55 EST 2010 | ssager
Thanks guys, It sounds like adding redundancy and audits to the process is the best low cost option.
Electronics Forum | Wed Jan 05 13:28:19 EST 2011 | ehess
what does nitrogen do to assist the selective soldering process?
Electronics Forum | Mon Feb 28 23:07:04 EST 2011 | kemasta
It is random. By the way, this board pass thought wave process, (BGA is at the top), will that cause the older short issue?